Wren HYPERION HYP-SPK15-W User manual

INSTALLATION GUIDE
HYPERION GATEWAY
HYP-SPK15-W

Prior to installation, verify that all hardware is
included. If there are missing components,
please contact Wren.
COMPONENT LIST
Hyperion Horn Speaker
REQUIRED TOOLS AND ACCESSORIES
#2 Phillips screwdriver Drill Cables (18/2 AWG min.)
NOTE: MOUNTING HARDWARE IS NOT PROVIDED. BESURE TO USE
APPROPRIATE FASTENERS AND ACHORS FOR THE MOUNTING SURFACE.
Hyperion Gateway Installation Guide www.wrensolutions.com 7L587 Rev 190510
IDENTIFY AN APPROPRIATE MOUNTING LOCATION
1
Mounting Surface
The HYP-SPK15-W should be mounted to a structurally
solid wall or ceiling surface.
Mounting Height
The minimum recommended mounting height for this
device is 8’ from ground level.
Mounting
Mount stainless steel mounting bracket at desired
location. Using appropriate hardware (Fasteners and
anchors are not provided).
3 CONNECT GATEWAY
NOTE: More information can be found in the
Gateway User Guide.
The gateway supports two,
independent audio channels, each with
separate connection ports and volume
adjustment.
Attach speaker wires to the Gateway,
making sure to note polarity.
2 CONNECT SPEAKER
Attach the speaker wires to the
speaker, making sure to note
polarity.
NOTE: WERECOMMEND USING
18 AWG WIRE OR LARGER AND A
MAXIMUM RUN OF 500 FEET IN
ORDER TO MAINTAIN AUDIO
VOLUME AND CLARITY