Wrightline PFPDARM1 User manual

page 1 of 17
PFPDARM1
Product Illustration

page 2 of 17
PFPDARM1Components &
Fasteners
TOOLS REQUIRED
Phillips Screwdriver
1/2" Wrench
1/2" Socket Wrench
ؽ"
ؽ"
4x
1x
1x
4x
8x
4x
3/32"
(2.38mm) 3/16"
(4.76mm) 1/8" (3.17mm)
1 each

page 3 of 17
Use the Phillips Screwdriver to loosen (but not remove) slatwall bracket
screws.The upper and lower slatwall brackets will move apart.
STEP 1
Install to Slatwall.

page 4 of 17
With screws still installed, hook the slat wall bracket onto the slatwall.
Use the Phillips Screwdriver to tighten screws,drawing upper and lower slatwall brackets toward
one another.

page 5 of 17
STEP 2
Installation Instructions for Monitors with the following hole mounting patterns:
75mm VESA® FPMPMI™ Standard Hole Mount*
100mm VESA® FPMPMI™ Standard Hole Mount*
Custom - does not comply with VESA® FPMPMI™ hole pattern standards*
* VESA® (Video Electronics Standard Association)
FPMPMI™(Flat Panel Monitor Physical Mounting
Interface)

page 6 of 17
STEP 2 continued
Remove monitor pivot from slide bracket.

page 7 of 17
M4 x 10mm
STEP 2a
For monitors with a 75mm VESA®FPMPMI™hole pattern:
Attach monitor directl to pivot.
4x

page 8 of 17
Attach monitor to adapter plate/pivot assembly.
#8-32 x 3/16"
3/32"
(2.38mm)
Attach 75 to 100mm adapter plate to pivot.
M4 x 10mm
STEP 2b
For monitors with a 100mm VESA®FPMPMI™hole pattern:
4x
4x

page 9 of 17
STEP 2c
For monitors that are not compliant with VESA®FPMPMI™hole pattern standards:contact
your APW Wright-line customer service representative.

page 10 of 17
STEP 3
Re-attach
p
ivot (with monitor installed) to slide bracket
.
NOTE: Make sure that the curve on the back
of the pivot wraps around the slide bracket.
Do not overtighten
the pivot knob.