Wyze WYZECAM WYZEC1-KSZP01 User manual

WYZEC1-KSZP01 V1.0 正
WYZEC1-KSZP01 V1.0 背
Cool Gray 9C
IN THE BOX
WyzeCam
USB Cable
Power Adapter
x1
x1
x1
Light Sensor
Lens
Microphone
MicroSD Slot
(SD card not included)
Reset Button
Power Input
Status Light
USB Output
4
3
2
1
3
2
1
5
8
7
6
5
4
7
6
8
Quick Start Guide
Wall Plate
Mounting Tape
x1
x1
x1
SETUP
Download the Wyze app
and create an account
Follow the Wyze app to
finish setup
Press the reset button for 3
seconds until you hear a
voice prompt
Connect the camera to a
power outlet and wait for
20 seconds until the
yellow status light flashes
4
3
2
1
FAQ & warranty
www.wyzecam.com/support
Monday-Friday 9AM-5PM PST
[email protected]
1-844-WYZECAM
CONTACT US
LIGHT INDICATIONS
Solid yellow light
The device is powered on and initializing
Solid blue light
The device is working properly
Flashing yellow light
The device is ready to connect
Flashing yellow & blue lights
Connection is in progress
Flashing blue light
The device is connected and finishing setup
@wyzecam
App Store
Google Play
Wyze

Warning Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
