X-Stand PATRON XSFP456 Quick guide
□�@
TREESTANDS
™
™
8
™
L
k
8
™
X-ST ANIJ.C:C)"
XSFP456 PATRON
350
ASTM
Q
FALLS FROMATREE STAND CAN OCCUR ANYTIME AFTER LEAVING THE GROUND.
THESE FALLS COULD RESULT IN EITHER SERIOUS INJURY OR DEATH! FORYOUR PERSONAL SAFETY,
PLEASE TAKE A MOMENT TO CAREFULLY READ THIS PRODUCTINSTRUCTION MANUALIN ITS ENTIRE-
TY BEFORE ATTEMPTINGTO ASSEMBLE, SET-UP,INSTALLAND/OR OTHERWISE USETHIS X-STAND
PRODUCT. AT LEASTANNUALLY, REVIEWTHE CONTENTS OF THIS INSTRUCTION MANUALAND
WATCHTHE SAFE DURATIONTHATYOU OWNTHIS PRODUCT(S). FAILURE TO FOLLOWTHESE IN-
STRUCTIONS MAY RESULT IN SERIOUS INJURYOR DEATH.
TM
ASTM
Q
To activate your product's warranty, a registration card (found in the back of this manual)
must be completed and returned to the manufacturer within 30 days of purchase.
Be sure to keep a copy of this card for your records.
Should you have any questions about the assembly, installation or use of this X-Stand
product, or any other X-Stand products, please do not hesitate to call one of our customer
service representatives at 540-877-2769 and they will answer all questions you may have
about any of the complete line of X-Stand products.
READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT. 7
This instruction manual complies with ASTM F2337 Standard Test Method r Treestand Fall Arrest Systems.
XSFP456 - PARTS LIST
/
、
奂、
�
、
＠
＠
＠
＠
/
守
8
K9昌令'IIIIIIIIII
- _
－－
i6I
IIII
1/4" Spacer
1/4" spacer ,
�]
、
、、
、、
、、
、
、、
、
、、
、、
、
、、
、、
、、
、
、、
、、
、、
、
、
、
、、
、
、
、
、
、
READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.
is instruction manual complies with AS F2 7 23 Standard Practice for Treestand Instruction.
9
XSFP456 PATRON
It will be necessary to use the climbing belt with your full-body fall arrest harness
while ascending the tree and attaching your treestand. As you climb it will be necessary to
slide the climbing belt up the tree. Once you've reached the desired height and your
treestand is properly secured to the tree, you will need to attach the permanent tree belt
and secure tether strap as illustrated on page 5 of this manual. FAILURE TO WEAR YOUR
FULL-BODY FALL ARREST HARNESS AT ALL TIMES WHILE USING THIS PRODUCT
MAY RESULT IN SERIOUS INJURY OR DEATH!
Prior to installing your X-Stand hang-on treestand, you must install a climbing
system (i.e., stacking sticks, ladders, sectionals, etc.) which meets or exceeds ASTM
standards. Failure to follow these instructions may r esult in serious injury or death!
DO NOT attempt to install this product on a tree that is not straight, healthy,
and devoid of dead branches, limbs, vines, or anything that might interfere with the
installation. DO NOT attempt to install this treestand on a tree that is leaning, diseased,
crooked, has loose bark, or does not meet the minimum installation diameter of nine (9)
inches (23 cm) at treestand height (i.e. seating platform height) or exceeds the maximum
installation diameter of twenty (20) inches (51cm) at treestand height (i.e. seating platform
height).
Assembly Instructions for the Patron
1
K
[I]
[
，＇
，
＇
，＇
，＇
，
，
＇
,J
，＇
lJ
_
r
o
[
J
J
厂lL
＿
FIELD INSTALLATION �
-PATRON-
Once you reach the desired treestand in-
stallation height, re-check to ensure your lines-man/
climbing belt is properly secured to you and the tree.
Make certain you are balanced and secure on your
climbing system.
Next install your Quick Hitch Receiver by securing the
loop end of the ratchet strap around the strap post of the
receiver. Then wrap the ratchet strap around the tree and
secure the opposite loop end around the other strap post .
Ratchet the strap tight to secure Hitch Receiver.
Next pull up your hang-on treestand. (Figure 1)
8.
This instruction manual complies with ASTM F2723 Standard Practice r Treestand Instruction.
乒I
READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT. I 13
HANG-ON AND CLIMBING SYSTEM WARNINGS & PRODUCT REGISTRATION
To activate your product's warranty, please mail in your registration card or submit it online at www. X-Stand.com
X-Stand Treestands I 21673 Cedar Avenue South I Lakeville, MN 55044
STANDARD LIMITED WARRANTY
™ ™
™
™
™
™
™
™
™
™
™
™
™
™
™
™
™
READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT. 15
This instruction manual complies with ASTM F2123 Standard Practice r Treestand Instruction.
'1
4
I , .
21763 Cedar Avenue South I Lakeville, MN 55044 I 540-877-2769 • Fax: 952-236-6458
This X-Stand
™
product(s) has been tested to rigid industry standards. Safe operation and use of this X-Stand
™
product(s) is the
responsibility of the user(s). Please read and follow all saf e use instructions and warnings. Failure to follow these may result in
serious injury or death! Third Edition, March 2018, Published by X-Stand™ Treestands, Lakeville Minnesota.
© 2017 X-Stand™ Treestands. All rights reserved.
Table of contents
Other X-Stand Rack & Stand manuals
