XSFP456 PATRON
It will be necessary to use the climbing belt with your full-body fall arrest harness
while ascending the tree and attaching your treestand. As you climb it will be necessary to
slide the climbing belt up the tree. Once you've reached the desired height and your
treestand is properly secured to the tree, you will need to attach the permanent tree belt
and secure tether strap as illustrated on page 5 of this manual. FAILURE TO WEAR YOUR
FULL-BODY FALL ARREST HARNESS AT ALL TIMES WHILE USING THIS PRODUCT
MAY RESULT IN SERIOUS INJURY OR DEATH!
Prior to installing your X-Stand hang-on treestand, you must install a climbing
system (i.e., stacking sticks, ladders, sectionals, etc.) which meets or exceeds ASTM
standards. Failure to follow these instructions may r esult in serious injury or death!
DO NOT attempt to install this product on a tree that is not straight, healthy,
and devoid of dead branches, limbs, vines, or anything that might interfere with the
installation. DO NOT attempt to install this treestand on a tree that is leaning, diseased,
crooked, has loose bark, or does not meet the minimum installation diameter of nine (9)
inches (23 cm) at treestand height (i.e. seating platform height) or exceeds the maximum
installation diameter of twenty (20) inches (51cm) at treestand height (i.e. seating platform
height).
Assembly Instructions for the Patron
1
K
