4
FCC Information
·NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Thisdevice complies with Part15 of the FCCRules. Operation is subject tothe
followingtwoconditions: (1)This devicemaynot causeharmful interference,and
(2)thisdevice mustaccept any interferencereceived, includinginterferencethat
maycauseundesiredoperation.
Theuseriscautioned that changesormodificationsnot expressly approvedbyXM®
SatelliteRadio,Inc. canvoidthe user’sauthoritytooperate thisdevice.
Please note that the cables that have been supplied with your XMC10 car cradle
are supplied with permanently attached ferrite beads. It is the responsibility of
the user to use the cable with the ferrite beads.
Byadheringto thesewarningsand safetyconsiderations, stated inthe manualand
byXM®,accidents.