Xplore Q2 User manual

Q2 Dash camera
User Manual

Content Guide
1Product Structure Diagram
2The Key Function Description
3The Installation Guide
4Basic instructions for camera / photo operation
5APP Operation Instructions
6Product Parameters
7Difficult Problem Solution

Product Structure Diagram
1 Emergency video and return key
2 Camera & Up button
3 Down button & Playback
4 OK key&ON/OFF
5 TF card slot
6 Micro USB
7 Reset

The Key Function Description
1 Emergency video and return key: Short press during the recording process, the video file will be
locked; menu interface to perform the return function
2 Snapshot & Up button: The video interface takes a short shot and in the menu mode.
3 Down button & Playback: Short press the video mode to enter the video playback mode
(video/playback). In the menu interface is the down selection key
4 OK key & ON/OFF: the menu interface is the confirmation key, the video interface short press,
enter the menu function; other interface long press to start & shutdown;
5 Reset button: Press the reset button in the dead state, the machine reboots

The Installation Guide
1. Turn off the car engine
2. Find the proper position in the car, install the bracket and hang the recorder. The
installation position is not to affect the driving. Then wipe the glass in the installation
position.
3. Adjust the lens position to ensure that the lens is level with the ground.
4. One end of the USB cable is plugged into the recorder's USB port and the other end is
connected to the car's USB port.
5. Start the engine and check that the machine is installed correctly.

Basic instructions for camera / photo operation
Camera mode
The machine opens the opportunity to enter the recording state. The video icon flashes in
the upper left corner of the screen. In the recording, you can click the setting interface to
enter the menu interface.
Photo mode
In the recording state, you can press the button to take a photo directly. When you take a
picture, the machine will send a “click” sound to indicate that the photo is taken; the key
can be switched to the playback mode.
Video/photo playback
Press key in video mode to switch to playback mode.
Short press go back to the video interface.；
Short press can upward selection file；
Short press can downward selection file；
Short press Key to play selected video files

Menu setting
In video mode，Short press menu key ，Access menu，
Short press Return to the video interface；
Short press can upward Select the settings item；
Short press can downward Select the settings item；
Short press C hange the current settings item
USB Mode
USB cable Connect to the PC，Camera will automatically pop up the USB menu，The following
options appear:
Storage: Storage of video or photo files；
Camera: Can be used as webcam in this mode;
Recorder mode:Video can be recorded in this mode

App operation
Install mobile phone APP
Android system mobile phone
1. open “Google Play” search “DV running2” Or
scan the following QR code download installation.
Apple IOS system phone
1. open APP Store search “DV running2” Or scan
the following QR code download installation.

WiFi connect
For the first connection, you need to enter WiFi to set up search WiFi and enter the password
Reconnect no password required.
1.Mobile search WiF Name of wifi_camera******** Camera password 12345678.
2.Click on connection
After the connection between the phone and the camera is successful, open the app to see the
camera video

Product Parameters
Hardware parameters:
P
rocessor type
J
erry 5601
Image sensor
BG0806
D
isplay screen
2
.7inch 960*240 RGB hold
L
ens video effective pixels
2
00W
Video format
MOV
M
icrophone
s
upport
Operating Voltage
5V
Memory
SD block
O
perating temperature (°C)
-
20℃-70 ℃
Features
：
language support
English, Spanish, German, Italian, Chinese, Russian, Japanese
L
oop recording
1
minute, 3 minutes
Parking monitoring
support
G
ravity sensor
s
upport
O
ne-button lock function
s
upport
Recording function
support
Note: This product reserves the right to
change designs and specifications
without notice. If there is any difference,
please refer to the actual product.

Troubleshooting:
Under normal operating conditions, if there is a problem with the product, please refer to the
following solutions:
The recorder shows that the memory is full and cannot record video:
1. The first time the new card is used on the machine, the machine will prompt you to format the
TF card first. Please format it first! If there is no prompt, please format it before use
2.Check if the sensitivity of G-sensor is set to high. If the sensitivity is too high, the car jolts and
shakes the machine during the driving process. This will cause the file to be locked. The locked file
cannot be overwritten. If the lock file is accumulated, the memory is full. cycle.
Slow reaction of screen card or button during recording:
Please check whether the used memory card is a Class 10 card. If you use a non-high-speed card,
problems such as missing seconds, video playback cards, corruption, and crash may occur. (At the
same time because the quality of the market's high-speed card is uneven, you should buy a brand
memory card)

The fog of images
Check the lens for fingerprints and dirt, and use lens paper/cloth to wipe the lens and clean the
front windshield.
Crash
After the crash, use a sharp object to short press the reset button to restart the machine

Q2 Dash camera
Priručnik za korisnike

Sadržaj
1Izgled proizvoda
2 Funkcije tipki
3Vodič za postavljanje
4Opće upute za korištenje
5Upute za korištenje aplikacije
6Specifikacije proizvoda
7Rješavanje problema

Izgled proizvoda
1 Tipka za povrat i snimanje u nuždi
2 Tipka za kameru & gore
3 Tipka za reprodukciju & dolje
4 OK & ON/OFF tipka
5 Utor za TF (Micro SD karticu)
6 Mikro USB
7 Reset

Funkcije tipki
1 Tipka za povrat i snimanje u nuždi: u video načinu služi za zaključavanje snimke, u sučelju
izbornika služi za povrat
2 Tipka za kameru & gore: u foto/video načinu služi za okidanje fotografija, u sučelju izbornika za
kretanje prema gore
3 Tipka za reprodukciju & dolje: U video načinu služi za reprodukciju, u sučelju izbornika služi za
kretanje prema dolje
4 OK & ON/OFF tipka: u sučelju izbornika služi za potvrđivanje, u video načinu služi za ulazak u
izbornik, za ukljućenje i iskljućenje potrebno je držati 2 sekunde
5 Tipka za reset: na pritisak resetira uređaj

Upute za postavljanje
1.Zaustavite motor automobile.
2. Pronađite odgovarajuću pozijiu, postavite nosač i umetnite kameru. Pozicija kamere ne smije
ometati vožnju.
3. Podesite kameru tako da je donji dio vidnog polja poravnat s podom.
4.Priključite kameru na USB punjač.
5.Pokrenite motor automobila i uključite kameru

Opće upute za korištenje
Video način
U video načinu će se u gornjem lijevom uglu ekrana pojaviti ikona kamere
Foto način
U foto načinu ili tijekom snimanja videa možete okinuti fotografiju (kamera će se odazvati zvučnim
signalom što znači da je fotografija uspješno snimljena)
Video/Foto reprodukcija
Pritisnite tipku u video načinu da biste ušli u način za reprodukciju
Pritisnite kako biste se vratili u video način
Pritisnite kako bi pomaknuli odabir prema gore
Pritisnite kako bi pomaknuli odabir prema dolje
Pritisnite za reprodukciju fotografije/videozapisa

Izbornik
U video načinu pritisnite kako biste pristupili izborniku
Pritisnite za povrat u video način
Pritisnite za pomicanje odabira prema gore
Pritisnite za pomicanje odabira prema dolje
Pritisnite za promjenu trenutne postavke
USB način
Kada se kamerа poveže putem USB kabla na računalo, na ekranu će se pojaviti
Pohrana；
Kamera (web kamera);
Snimanje

Upute za korištenje aplikacije ：
Instalirajte mobilnu aplikaciju
Android uređaj
1. Otvorite “Google Play” i utipkajte “DV running2” ili
skenirajte QR kod
Apple iOS uređaj
1.Otvorite “APP Store” i utipkajte “DV running2” ili
skenirajte QR kod