Y!mobile GP02 User manual

INSTRUCTION for the Pocket Wi-fi(GP02-rev)
1.Charge Battery
a) From wall socket(outlet). Full charge takes 4 hours
b) From PC(USB)
Full charge takes 6 hours
2.Power On/Off
Power on
Push Power button 5sec to turn
on the device. The device will
automatically connect to 3G
network.
Power off
Push Power button 5sec to turn off.
★Saving mode
The ocket WiFi will automatically switch to energy
saving mode if not used for around 10minutes ress the
ower button for 1sec. to turn it back on.
3. Set up Wi Fi for Laptop or iPhone/iPad
a) For Laptop
- Select Control Panel from “Start Menu”
- Select “Network and Sharing Center”, then click Connect
to Network.
-Select SSID “GP02-xxxx” or back of the ocket wifi then
click connect.
-Ty e in WEP key. Your WEP key is on the back of
Pocket Wi-Fi device. Then save.
b) For iPhone/iPad
- Select Settings icon and General, then touch ”Network”
and Wi-Fi.
-Select SSID “GP02-xxxx” or back of the ocket wifi then
click connect.
-Ty e in WEP key. Your WEP key is on the back
Pocket Wi-Fi device. Then save.

Reset Pocket Wi-Fi
If you have any issues, Please reset Pocket
Wi-Fi Device as following.
(Some PW oesn’t have reset)
Please open the battery cover,
then press reset button.
Return
Checklist
1. Pocket Wi-Fi evice.
2. AC charger
3. USB cable
4. This Manual
- Prohibited Actions –
-Do not open Pocket Wi-fi.
-Do not remove SIM Card from the device.
-Do not use the device outside Japan. If ou do, ou will
be charged the expensive roaming fee.
Support center
Phone [phone]
(Start from the other side )
Don
’
t push
it too
much.