Yamaha FX Audio Kit User manual

7/2019 F3X_H81E0_T0_A MANUAL, INSTALL
AUDIO SET
Page 1 of 3
©Yamaha Motor Corporation, U.S.A. All rights reserved.
INSTALLATION INSTRUCTIONS
DESCRIPTION: FX Audio Kit
PART NUMBER: F3X-H81C0-T0
MODEL: 2019~ FX WaveRunner®
Please read and understand these instructions
completely before installation to avoid possible
injury, or damage to the accessory or vehicle.
WARRANTY INFORMATION:
In the United States, see your Yamaha dealer for a copy
of the Genuine Yamaha Accessories Limited Warranty
statement.
DEALER OR INSTALLER:
These instructions contain important information for
future reference and must be given to the customer.
NOTICES:
This installation requires a torque wrench and should be
performed by an authorized Yamaha dealer or other quali-
fied technician.
PARTS LIST:
No. Part Number Description Qty
-- F3X-H81C0-T0 FX Audio Kit --
-- EcoXGear speaker 2
-- Speaker mounting base 2
F3X-U7823-11 M6 Flanged Button Head bolt 3
* Part supplied with kit only and not available separately.
1
1
3
3
2
2

7/2019 F3X_H81E0_T0_A MANUAL, INSTALL
AUDIO SET
Page 2 of 3
©Yamaha Motor Corporation, U.S.A. All rights reserved.
PREPARATION:
• Ensure the WaveRunner®is on a secure stand or trailer and level surface.
• Clean all mounting surfaces before beginning installation.
• It is recommended to have the factory service manual available for reference.
INSTALLATION:
1. Remove the Multi-Mount Base and Cup Holder Extension, if fitted. Retain the hardware to use later in the install.
3. Tighten screws to 44 in-lb (5Nm).
2. Install EcoXGear mounting base into the cup
holder on the unit. Secure with the screws retained in
Step 1. If you do not have a Cup Holder Extension,
use the three flanged button head screws supplied
with this kit.

7/2019 F3X_H81E0_T0_A MANUAL, INSTALL
AUDIO SET
Page 3 of 3
©Yamaha Motor Corporation, U.S.A. All rights reserved.
CARE AND CLEANING:
Clean plastic parts with a clean soft cloth and mild soap
and water. Rinse and dry. Always rinse with freshwater
after salt water use.
CUSTOMER SERVICE:
For further information see your Yamaha dealer.
ESTIMATED TIME TO INSTALL: 0.2 HRS
5. Put speaker in mount base.
4. Pull quick-release knob and turn 90 degrees
into indentation.
8. Repeat steps for the other side of the WaveRunner®.
MAINTENANCE:
Periodically, check torque on all hardware. If loose
hardware is found, re-torque to specification.
6. Position speaker to desired angle / direction.
7. Turn quick-release knob back to original position. Seat
the knob into the indentation. Confirm it is fully
seated and no red color is visible.