
2En
English
■CONNECTIONS
y
Notes
•Connect the (+) terminals on the amplier and the
speaker using one side of the cable. Connect the
(–) terminals on both components using the other
side of the cable.
•Connect the speaker to the center terminals of your
amplier, making sure not to reverse the polarity
(+, –). If the speaker is connected with reversed
polarity, the sound will be unnatural and lack bass.
•When using an amplier with a rated output power
higher than the nominal input power of the speaker,
care should be taken never to exceed the speaker’s
maximum input.
•The speaker may be damaged if certain sounds
are continuously output at high volume level.
For example, if sine waves from a test disc, bass
sounds from electronic instruments, etc., are
continuously output, or when the stylus of a
turntable touches the surface of a disc, reduce the
volume level to prevent the speaker from being
damaged.
•Please refer to the owner’s manual that came with
your amplier or receiver.
How to connect:
1 2 15 mm
(5/8")
3 4 5 Notes
•Do not let the bare speaker wires touch each other
as this could damage the speaker or the amplier,
or both of them.
•Do not insert the insulation coating into the hole.
The sound may not be produced.
When using a banana plug
1
2
Banana plug
CONNECTION TO YOUR AMPLIFIER
Before making connection, make sure that the amplifier is switched off.
Amplifier
NS-C901
Tighten
Black (–) Red (+)
Loosen
Insulation coating
Bare wire