Yard force YF-SC600ECO User manual

> 1 m
> 2 m
Quick start of Robot mower
1
2
Place the charging station
Make sure that the garden ground is even and
free of obstacles such as stones, branches.
Remove them if there is.
Select S1 or S2 with the
signal button. It is to
prevent disturbance
with your neighbor
who runs a same robot.
On your mowing robot,
the same setting must
be selected both on the
robot itself and charging
station (S1 or S2).
3
5Programming the mowing robot
4
Begin with the
maximum cutting
height and gradually
reduce it to the
desired cut height.
Main switch
On/Off switch Cutting height adjust
＜100 m2
10 Ω
A
C
Set the boundary wire
with pegs.
E
J
A
I
A
B
A
Close the cover
C
D
For a lawn area less than
100 m2 or the boundary total
length is less than 40m.
You need a 10 Ω/20 W
cement resistor in boundary.
A
Stripping pliers
10 - 15 mm
G
Possible position of the
charging station
End point of the
boundary wire
1 meter of wire reserved for
possible adjustments
Start point of
the boundary
wire
D
The pegs and the boundary wire
should be as close as possible to
the ground to prevent tripping.
F
H
In front of the loading station, a
straight wire length of 2 m is required.
Beside the charging station
there should be 1m wide
Flat area.
B
To unlock, press 4 times
this “lock” button Please press “Start”
Select the mowing hours that the
robot should work
®

OK
NO
The boundary wire must never cross.
> 2m
> 10 cm
> 10 cm
< 5 mm
< 27°
> 40 cm
Boundary wire
< 8m
>2m
> 10 m
40 cm
80 cm
S1 S2
> 0.5 m
Buffer zone
If you prefer mowing robot to
travel over the two parallel
boundary wires, the gap distance
of wires above showed must be
less than 5 mm. If the mowing
robot only runs in a circle in
the home mode, please put
a post or obstacle at position A.
If the mowing robot is not to cross the
boundary wire, the distance between
the two wires must be at least 10 cm.
-
Please note the installation
DVD in the box.
> 10 m
Setting of boundary wire
®