manuals.online logo
Brands
  1. Home
  2. •
  3. Brands
  4. •
  5. YS
  6. •
  7. Rack & Stand
  8. •
  9. YS Super Mount 3 User manual

YS Super Mount 3 User manual

This manual suits for next models

4

Popular Rack & Stand manuals by other brands

Dynex DX-MP3MT Quick setup guide

Dynex

Dynex DX-MP3MT Quick setup guide

Konig & Meyer 24185 manual

Konig & Meyer

Konig & Meyer 24185 manual

ECG LD 326501 instruction manual

ECG

ECG LD 326501 instruction manual

Philips SB7S19S/00 quick start guide

Philips

Philips SB7S19S/00 quick start guide

Woodline KIT-250 lb instructions

Woodline

Woodline KIT-250 lb instructions

ricoo S1222 installation instructions

ricoo

ricoo S1222 installation instructions

Kanto P301 user manual

Kanto

Kanto P301 user manual

VidaBox VB MNT FFS2 installation guide

VidaBox

VidaBox VB MNT FFS2 installation guide

PROEL PLWIN60C user manual

PROEL

PROEL PLWIN60C user manual

AllMounts PLB-43S instruction manual

AllMounts

AllMounts PLB-43S instruction manual

VMP VH-001 instruction sheet

VMP

VMP VH-001 instruction sheet

Nederman SYSTEM 920/400 instruction manual

Nederman

Nederman SYSTEM 920/400 instruction manual

Glasdon ORBIS POST MOUNTING KIT installation guide

Glasdon

Glasdon ORBIS POST MOUNTING KIT installation guide

Songmics LGR105 manual

Songmics

Songmics LGR105 manual

Grape GM401 user manual

Grape

Grape GM401 user manual

FourStarGroup 11225296 manual

FourStarGroup

FourStarGroup 11225296 manual

CHIEF FLR100 installation instructions

CHIEF

CHIEF FLR100 installation instructions

FEC XDCAM EX PMW-EX30 manual

FEC

FEC XDCAM EX PMW-EX30 manual

manuals.online logo
manuals.online logoBrands
  • About & Mission
  • Contact us
  • Privacy Policy
  • Terms and Conditions

Copyright 2025 Manuals.Online. All Rights Reserved.

FEATURES
Equipped with an oil damper and soft rubber rings front and rear will dramatically
reduce vibration and noise compared to conventional engine mounts. Limiting the
engine only to pivot arount the center line of the crankshaft will minimize spinner
wobble and reduce airframe vibration.
INSTALLATION
1. Install the Damper ball support #6 to the carburetor body using liquid thread lock
and secure in place.
2. Install #3 rear mount asembly using #4 screws.
3. Install #5 oil damper as shown in drawing.
4. Install #2 front nose ring assembly by sliding it over the engine case.
Note: DO NOT ALLOW ENGINE DRIVE WASHER TO RUB ON NOSE RING.
5. The engine is now ready to be installed in the airplane.
6. The engine will vibrate from side to side. You will need to make the proper
clearance under as well as on top of the engine. If the engine is able to hit the
airframe this may cause damage to the engine and or airframe.
HOW TO OPERATE
1. Since the engine will vibrate from side to side, make sure it will not hit the air-
frame at any time. The engine will vibrate the most during the time it is at idle and
at full throttle the engine will subside and lean to the left (viewing it from the front)
due to the torque of the engine.
2. TheOilDamperislledwithoilandcanbechangedtoadifferentgradeofoilto
suit your performance. The oil used at the YS factory is Tamiya Damper Oil #600.
MAINTENANCE
1. The YS Super Mount was designed to absorb vibration and should be checked
regularly making sure nothing is abnormally loose or broken.
2. Addingorchangingthedamperisdonebyrstremovingitfromtheengine
mount. Hold the widest part of the damper straight up edge and reinstall the cap.
SAFETY PRECAUTIONS
1. Always check and secure the mount on a regular basis.
2. Do not use if any part of the mount is loose or broken.
3. The YS Super Mount is an accessory unit for the DZ170, DZ160, DZ140,
FZ140-2 and follow the precaution for safe operations of your engine manual.
WARRANTY
Should this product fail to function peroperly during normal operations for the time
period of one year, we will repair it without charge in the limited cases where the
malfunctioncanbedeemedattributabletoamanufacturingdefect.Anymodication
to the YS Super Mount will void all warranty.
YS Super Mount 3 ( DZ185,175,170,160 )
67 Tsuchitori Inuyama Aichi Japan
TEL: 0568 67 0265 FAX: 0568 67 7801
YAMADA MFG.CO.,LTD
.
57
136.5
14
119.4
68.6
149.5
63 25
58
113.7
1
2
3
4
5
6
Parts No. Description QTY
1 Engine 1
2 M0020 Nose Ring Assembly 1
M0021 Nose Ring Inner Case 1
M0022 Nose Ring Inner Rubber 1
3 M2030 Rear Mount Assembly 1
M2031 Rear Mount 1
M0032 Rear Mount Arm 1
M0033 Rear Mounrt Arm Screws 2
4 M0040 Rear Mount Screws 3
5 M0060 Oil Damper 1
6 M0070 Ball Support 1
MN140 TeflonTape 1