zerhunt QB-803 User manual

BUBBLE MACHINE
Model No.: QB-803
USER INSTRUCTIONS

1
Introduction
Thank you for purchasing our Bubble Machine. This instruction manual
contains important information about safety, usage, and disposal.
Use the product as described and keep this manual for future reference.
If you sell this bubble machine or pass it on, also give this manual to the
new owner.
Product Description
1. Battery Compartment
2. Handle
3. ON/OFF/Speed Switch
4. Bubble Wand
5. Tank
6. DC-IN Jack
Safety Instructions
• This product is only authorized for domestic use and not for commercial
or industrial purposes. It is only intended for applications described in
these instructions.
• Children or dependents should not use, clean, or perform maintenance
on the bubble machine without adult supervision.
• Only connect the bubble machine to a power outlet type as indicated
in the "Specifications" section of this manual.
• To completely disconnect from power, remove the batteries and unplug
the power adapter.
• Make sure the power cable is visible at all times to avoid stepping on
or tripping over it.
• The machine should not be exposed to dripping or splashing water.
If moisture, water, or any liquid gets inside the housing, immediately
unplug from power and contact a qualified technician to check and
repair it.
• Do not open the housing of the bubble machine. There are no

2
user-serviceable parts.
• Never leave the machine unattended when it is switched on or connected
to power.
• Never aim the bubble machine at open flames.
• Do not aim the bubble machine directly at people as bubble liquid
may leave permanent markings on clothing.
• Do not transport with liquid. If the machine gets wet, do not use until
it is completely dry.
• Always keep batteries out of the reach of infants and young children
to prevent the batteries from being swallowed. If swallowed, take
immediate action and contact medical authorities for help.
Operation
Included Items
1 x Bubble Machine
1 x Power Adapter
1 x Instruction Manual
Before using the bubble machine for the first time, check the package
contents to ensure all parts are free of visible damage.
Inserting Batteries (Optional)
To insert the batteries, unscrew the screw on the battery compartment
on the top of the machine and remove the compartment cover. Insert
6 C batteries (not included), paying attention to the correct polarity.
Handling and Operation
1. Place the bubble machine on a solid, flat surface and in a well-ventilated
area.
2. Pour bubble liquid into the liquid reservoir. Always ensure the liquid
level immerses at least one wand. Do not fill the reservoir over the
noted maximum level.
3. If batteries have not been installed, plug the bubble machine into a
grounded electrical outlet. If batteries are installed and the machine
is also connected to an outlet, then outlet power will be used.
4. Turn the ON/OFF/Speed Switch clockwise to Speed Level 1.
5. Turn the Switch again for Speed Level 2.

3
Attention:
It is normal for the bubble machine to produce less bubbles when
using battery power than when plugged in with the power adapter.
Note:
• Keep the air intake ports free from blockage.
• Do not use outdoors in the rain as this may lead to a short circuit.
• Do not leave unused liquid in the reservoir for an extended period.
The liquid may thicken in the reservoir. Remove all liquid before
storing or moving.
• If the bubble machine is to be mounted using a bracket, please note
the machine should only be inclined to a maximum angle of 15
degrees.
• The bubble machine should not be used for more than 8 hours
consecutively and is best operated at 40º-90ºF (4º-32ºC).
Performance of the machine may be reduced in low temperatures.
Cleaning
1. Empty all bubble liquid from the machine.
2. Rinse and drain the reservoir using a little distilled water.
3. Add some warm distilled water to the maximum level.
4. After adding water, turn on the bubble machine and allow it to run
in a well-ventilated area until all wands appear to be free of residue.
5. Drain the remaining water to complete cleaning.
Note:
• It is recommend to clean the bubble machine after every 40 hours of
operation.
• Do not spin the fan using compressed air to avoid damage.
• Always remove the power adapter from the socket before refilling
the liquid or cleaning the bubble machine.

4
Storage
• If you do not intend to use the bubble machine immediately, it is best to
unplug the power cord from the power socket, or remove the batteries.
• Once the machine has been disconnected from power, it is recommended
to empty the reservoir and store the machine in a dust-free and dry place.
Specifications
Power Input: AC100-240V,50-60Hz
Power Output: DC9V,1.2A
Power Consumption: Max 13W
Batteries: 6 x C size batteries (not included)
Spray Distance: 3-5m
Tank Capacity: max.400mL
Material: ABS
Dimension: 245*167*148mm
Weight: 834g
Disposal
Disposal of the Appliance
Under no circumstances should you dispose of the appliance in
normal domestic waste. This product is subject to the provisions
of European Directive 2012/19/EU.
Dispose of the appliance via an approved disposal company or your municipal waste
facility. Please observe currently applicable regulations. Please contact your waste
disposal center if you need any further information.
The appliance’s packaging is made from environmentally friendly
material and can be disposed of at your local recycling plant.