- 4 -
2. Manual pairing of devices
a. Use the switch POWER (25) to turn on the sound system. By pressing key [INPUT] or
remote [MODE] choose mode "bLUE".
b. Make sure that Bluetooth function has been activated in your Bluetooth device (for
example, smartphone). In order to do this, read your Bluetooth device user's manual.
c. When (Bluetooth ID) with title "DOMINATOR" is displayed in your Bluetooth device,
select it to begin connection in pair and establish a connection. After successful connection
in pair, the sound system conrms establishment of connection with sound signal.
e. If necessary, enter the default password "0000" (or other depending on the version of
your mobile device or software version).
• Use control elements of the Bluetooth device to select the track, playback mode and set
the initial volume (see the mobile device user's manual).
• If the previous connection of Bluetooth device has been with "DOMINATOR", next
connection will be automatic.
• Compatibility may not be provided for the Bluetooth devices to be manufactured in the future.
• In order to provide optimum connection, make sure the battery of your Bluetooth device
has been fully charged.
• Some Bluetooth devices have energy saving mode. Deactivate energy saving mode,
since it may cause data transmission disturbances.
• In case of incoming call to the connected smartphone, music playback is paused.
Reception of FM radio stations:
1. Use the switch POWER (25) to turn on the sound system. By pressing key [INPUT] or remote
[MODE] choose mode FM radio.
2. Shortly press the sound system key [ / AUTO] (14) or remote key [FM SCAN], and scanning
for range and memorization of radio station frequencies will begin; frequency will change on display
and shortly the memory cell number of the found transmitter will be shown (for example, "P02"), and
a short fragment of the transmission will be played.
For early stopping of scanning of FM radio stations, press the key [ / AUTO] (14).
When scanning of radio stations is over, broadcast of the rst found "P01" radio station will be played.
3. Temporarily pressing the key [ / VOL-] (15) or [ / VOL+](13), select any of the memorized
radio stations.
Connection of microphones:
Dynamic wireless microphone (included 2 pcs.) and/or dynamic microphone with cable can be
connected to the sound system.
1. Switch off the sound system by using the switch POWER (25).
2. Turn the echo controller ECHO (6), main volume controller VOLUME (9) and microphone
volume controller MIC VOL (3) to the minimum.
3. If you will use an additional microphone with a cable, connect the cable to the port MIC (18).
• Before the use of wireless microphone, two R6/AA 1.5V batteries must be inserted.
• Shift the wireless microphone switch in position ON (switched on).
4. Switch on the sound system by using the switch POWER (25).
5. Speak into the microphone and set the required volume by using the main volume controller
VOLUME (9) and the controller MIC VOL (3). Set the required echo level with the echo controller
ECHO (6).
6. If the microphone priority mode button OK PRI (1) will be locked in pressed position, then,
upon speaking into the microphone, sound from other signal source (for example, USB ash
memory) will be automatically toned down.
