ZUCCHETTI R97900 Parts list manual

R97900
ZT2545 - ZT2645 - ZT2750 - ZT2751
ISTRUZIONI PER L’INSTALLAZIONE DELLA RUBINETTERIA
I
INSTRUCTIONS FOR THE INSTALLATION OF THE FAUCETS
GB
INSTRUCTIONS POUR L’INSTALLATION DE LA ROBINETTERIE
F
MONTAGEANLEITUNGEN ZUR INSTALLATION DER ARMATUREN
D
INSTRUCCIONES PARA LA INSTALACION DE LA GRIFERIA
E
ИНСТРУКЦИИ ПО МОНТАЖУ СМЕСИТЕЛЬНОЙ АРМАТУРЫ
RU
INSTRUKCJE INSTALACJI ARMATURY
PL
Zucchetti Rubinetteria S.p.A.
Via Molini di Resiga, 29 - 28024 Gozzano (No) - Italy - Tel. [phone] - Fax [phone] - zucchettidesign.it
A30547 - 07/13 - R00
ZT2545 ZT2645 ZT2750 - ZT2751
R97900

Max. 24 mm.
Max. 0”7/16
Min 56mm.—2”3/16
Max 80mm.—3”1/16
COLLEGARE AL RUB. D’ARRESTO
CONNECTING WITH STOP VALVE TAPPARE SE NON UTILIZZATO
PLUG IF NOT USED
INSTALLAZIONE / INSTALLATION
ZT2545 - ZT2645 - ZT2750 - ZT2751
40mm-1”9/16
58mm-2”3/16
110mm-4”5/16
70mm-2”11/16

INSTALLAZIONE / INSTALLATION
ZT2545 - ZT2645 - ZT2750 - ZT2751

\
ZT2545
INSTALLAZIONE / INSTALLATION
ZT2545 - ZT2645 - ZT2750 - ZT2751

OPERATING INSTRUCTIONS:
The lowest handle has a degree scale and it controls the thermostatic element.
The button on the handle blocks the maximum rotation at 49°C (120°F) for safety and anti scald purposes.
ADJUST TEMPERATURE LIMIT STOP:
To increase or decrease the maximum temperature of hot water proceed as follows:
• By keeping the temperature handle upward, take off the cap and the fixing screw of the thermostatic han-
dle then the handle itself
• Unlock the white stop sleeve taking it out
• Turn the white stop sleeve clockwise (for colder water) or counter clockwise (for hotter water) and lock it
again pushing it
• Reassemble the thermostatic handle
SERVICE INSTRUCTIONS:
The thermostatic mixer is set at the factory at the temperature of 38°C (100°F).
If the temperature, of the mixed water, should not result at 38°C (100°F), proceed as follows:
• By keeping the temperature handle upward, take off the cap and the fixing screw of the thermostatic han-
dle then the handle itself
• Remove the white stop sleeve
• Turn the thermostatic cartridge pin clockwise (for colder water) or counter clockwise (for hotter water) till
the temperature of water of 38°C (100°F) is obtained
• Reassemble the white stop sleeve as shown in the picture below
• Reassemble the handle, keeping attention to have the button upward
CONDITION OF USE:
Product for use with shower heads rated at 9.5 L/min (2.5 gpm) or higher
INSTALLAZIONE / INSTALLATION
ZT2545 - ZT2645 - ZT2750 - ZT2751