ZyXEL Communications NBG334W Manual

1
NBG-334W/NBG-460N
Setup port-forwarding

2
Table of content
Introduction....................................................................................................................................................... 3
Equipment ..................................................................................................................................................... 3
Login .................................................................................................................................................................. 3
Setup Port-Forward ........................................................................................................................................... 4

3
Introduction
This guide describes how to setup port-forwarding on the NBG-334W with firmware 3.60(AMS.2)C0.
This guide can also be used on other products (e.g. NBG-460N).
Equipment
NBG-334W
1 Network cable. (RJ-45)
1 PC or MAC
Login
A web-browser are needed for configuring the NBG-334W. Some of the web browsers that can be used are
Chrome browser, Firefox, Internet Explorer, Opera, Safari and etc.
To enter the NBG-334W’s web-interface, open the web browser and access http://192.168.1.1/
Enter the login password and click login. The standard password is “1234”.
If this is the first time the router is being configured, the password should be changed.
Enter a new password in both the fields, and click Apply.

4
Setup Port-Forward
Click on “Network” and then on “NAT” in menu to the left.

5
Now click on the tab “Application”.
Fill out the following fields:
Check on the “Active” field.
Type or select the service name to forward
Type the Port number to forward, in the Virtual port
In Server IP Address you need to type the IP address of the PC/Server, the traffic shall be forwarded
to.
Click apply.
You have now setup a port-forward on the NBG-334W.