1 BY ONE O00QS-0061 User manual

www.1byone.com
www.1byone.com www.1byone.com
1
Maintenance and Cleaning
● Maintenance and cleaning shall only be done to the product surface. Unplug this product from
the power socket before cleaning.
● Do not wet any electric parts of this product. Please use a dry,soft cloth instead of sharp tools for
cleaning.
Cautions and Warnings
● Please read through this instructions manual before use.
● Before use,check the product to see if there is any crack in the product and outer adapter. Make
sure there is not any exposed wire.Do not use if any of the above conditions is found.
● Attention! Do not place the product onto wet or uneven surfaces.
● Disconnect this product from power immediately in case of malfunction. Do not resume use until
it’s repaired.
● Do not use outdoors.The product is not waterproof.
● This product is not a toy. Please keep this unit out of reach of children and pets.
● Close supervision is necessary when this product is used by invalids, or disabled persons, or near
children.
● Use this product only for its intended use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
● Never drop or insert any object into any opening.
● Please unplug the outer adapter from power socket if you want to stop use of this unit for long
time.
● If the outer adapter is damaged,you can replace with a new one with correct specifications
DC12V, 1500mA. Never operate this product if the outer adapter is damaged, if it is not working
properly, if it has been dropped or damaged, or dropped into water.
WEEE Directive & Product Disposal
At the end of its serviceable life, this product should not be treated as household or general waste.
It should be handed over to the applicable collection point for the recycling of electrical and
electronic equipment.
5
SKU: O00QS-0061
Super LED Dome Light
USER MANUAL
It is very important to install and operate this product according to the following instructions.
Failure to do so may render your guarantee void.
Accessories List
The product comes with
● 1 x Dome Light ● 1 x Outer Adapter ● 1 x User Manual
Specications
● Outer Adapter: input AC 110-240V,output: 12V 1500mA
● Product Power Consumption: 18W
● Dimension: 185×185×154mm（7.28×7.28×6.1in.)
● Main Materials: ABS and SPCC
● LED Wattage: 6 x 3W
● Light Source: 2pcs red LEDs, 1pc yellow LED,1pc green LED,1pc white LED, 1pc blue LED
● Working Modes: Auto-operation, sound activation, DMX512 with 6 channels control
Outer Adapter User ManualDome Light
Note: Under the sound control mode, user can adjust the sound sensitivity by turning the Sound
Sensitivity Knob at the back of the dome light.Turning the knob clockwise can increase the sound
sensitivity,while turning counterclockwise will reduce the sound sensitivity. Light flash, color change
and motor rotation will be faster if the music volume and sound sensitivity are higher,and vice versa.
1byone Products Inc.
1byone Products Inc.
1230 E Belmont Street, Ontario, CA 91761
Customer Service: [phone]
www.1byone.com
US
To ensure speedy handling of your issue,
please call or email us for assistance.
Phone: [phone]
(Mon-Fri 9:00am - 6:00pm PST)
Email: [email protected]
UK
To ensure speedy handling of your issue,
please call or email us for assistance.
Phone: [phone]
(Mon-Fri 9:00am - 6:00pm UTC)
Email: [email protected]
FR
Pour vous assurez une assistance rapide en
cas de problème, veuillez envoyer un e-mail.
Email: [email protected]
IT
Per supporto immediato in caso di bisogno,
la invitiamo a contattarci via email.
Email: [email protected]
CA
To ensure speedy handling of your issue,
please email us for assistance.
Email: [email protected]
DE
Für eine zügige Bearbeitung ihres Problems,
melden Sie sich bei uns wie folgt.
Email: [email protected]
ES
Para garantizar una rápida atención de su
problema, favor envíenos un email para
ayudarle.
Email: [email protected]
JP
お客様の問題が直ちに解決されるため、ぜ
ひメールにて弊社までご連絡ください。
Eメ ー ル：[email protected]
Customer Service/Kundenservice/Service Clients
Atención al cliente/Assistenza Clienti/
カスタマーサービス

www.1byone.com www.1byone.com www.1byone.com
2 3
Automatic Mode: If the Mode Display shows A1 ~ A8, it means the Dome Light is under Automatic
Mode. Please operate the product by referring to the following table to reach your required lighting
effect.
Names for Parts
4
Note: Under the sound control mode, user can adjust the sound sensitivity by turning the Sound
Sensitivity Knob at the back of the dome light.Turning the knob clockwise can increase the sound
sensitivity,while turning counterclockwise will reduce the sound sensitivity. Light flash, color
change and motor rotation will be faster if the music volume and sound sensitivity are higher,and
vice versa.
DMX512 Operation Instructions
Connect the DMX512 by insert the DMX512 plug into the DMX512 Input at the back of the dome
light.Turn on the product and operate by referring to the following table to reach your required
lighting effect.
1. MENU: to change the working modes 2. UP: to adjust the motor rotation speed to be higher
3. DOWN: to adjust the motor rotation speed to be lower
4. ENTER: to save the working mode 5. DMX 512 Indicator:DMX working indication light
6. DC Jack 7. Sound Sensitivity Knob
8. DMX512 Input 9. DMX512 Output
10. Mode Display
Installation
You can place the product onto a clean,flat and solid surface, close to the power socket. Or you can
install the product on the wall and ceiling according to the following sequence.
Note: Before installation, you need to prepare a drill and two fixing screws.All of these are not
supplied with the product.
1. Choose a place on the wall or ceiling where you want to install the dome light.
2. Fix the screws through the screw holes on the wall or ceiling.
How to Use?
1. Connect the outer adapter to the DC Jack at the back of product, and then insert the plug into
correct power socket.
2. Press the MENU button to select different working modes: Automatic Mode, Sound Control
Mode, DMX 512 Control Mode.
Automatic Working Mode
MENU UP Rotation Speed DOWN
Press UP or DOWN to adjust the rotation
speed from 0 to 9 rates
Function ENTER
MENU
Red, Green,White,
Yellow, Blue
A1
Press UP or DOWN to adjust the rotation
speed from 0 to 9 rates
A2
Press UP or DOWN to adjust the rotation
speed from 0 to 9 rates
A3
Press UP or DOWN to adjust the rotation
speed from 0 to 9 rates
A4
Press UP or DOWN to adjust the rotation
speed from 0 to 9 rates
A5
Random combination of
different colors.Color
combinations change.
Red
Green,Yellow
Blue,White
Red, Blue,White
Press UP or DOWN to adjust the rotation
speed from 0 to 9 rates
A6
Random combination of
different colors.Color
combinations change and flash
Press UP or DOWN to adjust the rotation
speed from 0 to 9 rates
A7
Random combination of
different colors. Color
combinations change
Press UP or DOWN to adjust the rotation
speed from 0 to 9 rates
A8
Press ENTER
button to save
the current
working mode.
Then turn off
the dome light
and turn on
again, and the
dome light will
start working
with the saved
mode
Sound Control Mode: If the Mode Display shows S1 and S2, it means the Dome Light is under Sound
Control Mode.If the Mode Display shows AXXX (XXX means 3 numbers from 000 to 255),it means
the Dome Light is under DMX 512 Control Mode.Please operate the product by referring to the
following table to reach your required lighting effect.
Sound Control Model / DMX 512 Control Mode
MENU UP Rotation Speed DOWN
Rotation speed can not be adjusted under
sound control mode.UP and DOWN
buttons do not work
Function ENTER
MENU
Press ENTER button
to save the current
working mode.
Then turn off the
dome light and turn
on again, and the
dome light will start
LED light flashes.
Motor would not rotate
S1
LED light flashes and color
changes. Motor rotation
controlled by ambient
sound volume and rhythm
Rotation speed can not be adjusted under
sound control mode.UP and DOWN
buttons do not work
S2
working with the
saved mode
Dome Light is controlled
by 6 channels of DMX512
DMX 512 control mode.Press UP o DOWN
to adjust DMX value from 000 to 255
RXXX
DMX512 Control and Operation
DMX Channel DMX512 Value Function Function Description
Red, Green,White,Yellow, Blue; automatic rotation
speed. (CH2 ~ CH6 unavailable)
CH2
Light would change according to the sound
volume and rhythm. No light when there is no
sound. (CH2 ~ CH6 unavailable)
CH2~CH5 channels control available
0 Red + Red light out; light would be brighter if
adjust upwards; 255 reaches top brightness. (Light
will flash if CH2, CH3 and CH4 control together.)
CH3
CH4
With only these DMX512 data range,CH6
channel control available
CH1
0 Green + Yellow light out; light would be brighter
if adjust upwards; 255 reaches top brightness.(Light
will flash if CH2, CH3 and CH4 control together.)
0 Blue + White light out; light would be brighter if
adjust upwards; 255 reaches top brightness. (Light
will flash if CH2, CH3 and CH4 control together.)
CH5 0 motor stops working; rotation speed would be
faster if adjust upwards; 255 reaches fastest.
CH6
141~210
0~255
0~70
71~140
211~255
0~255
0~255
0~255
0~255
Automatic
Sound Control
DMX512 Control
Start DMX.
Controlled by CH6
Green light
brightness control
Blue light
brightness control
Red light
brightness control
Rotation speed
adjustment
Flash speed
adjustment