6
•Confirm by pressing the Date/Time ↵but-
ton.
8.4 Application as a handheld device for
measuring current and voltage
•Set up the 3B NETlog™ equipment.
•Connect the voltage/current input of chan-
nel A or B, as desired.
•If necessary, disconnect any sensor which
might be connected to the same channel.
Setting and selecting measurement parame-
ters:
•Press the Channel ←button (the menu
DISPLAY SIGNAL 1 will appear on the
display).
•Select the desired measurement parame-
ter with the Rate ↑or Store ↓button.
•Select the mode of operation with the
Date/Time ↵button (the menu RANGE
SIGNAL 1 will appear on the display).
•Select the desired mode of operation with
the Rate ↑or Store ↓button.
•Confirm this selection with the Date/Time ↵
button (the menu DISPLAY SIGNAL 2 will
appear on the display).
•Select the desired measurement parame-
ter with the Rate ↑or Store ↓button.
•Select the desired mode of operation with
the Rate ↑ or Store ↓button.
•Confirm the selection with the
Date/Time ↵ button (a dot will appear in
front of the respective measurement pa-
rameter when operating manually).
The 3B NETlog™ device is ready to conduct
measurements.
8.5 Application as a handheld measuring
device with sensors
•Set up the 3B NETlog™ equipment.
•Connect the sensor to the relevant input
and remove the connections of the 4-mm
sockets from the same channel.
After the automatic sensor detection PROBE
DETECT… has been completed, the
3B NETlog™ equipment is ready to conduct
measurements.
8.6 Setting the sampling rate
•Press the Rate ↑button (the options list for
SAMPLE RATE will appear).
•Select the desired sampling rate with the
Rate ↑or Store ↓button.
•Press the Date/Time ↵button (the settings
STORE ANALOGUE INPUT 1, STORE
ANALOGUE INPUT 2 and STORE BI-
NARY INPUTS will appear in succession).
•Select YES or NO for each setting with the
Rate ↑ or Store ↓button and confirm with
the Date/Time ↵button (the subsequent
setting will appear after each confirmation).
8.7 Data logger
In data logger mode, the 3B NETlog™ equip-
ment records the data with a pre-selected
sampling rate and saves it internally. After
completing a measurement, the data can be
transferred onto a computer for evaluation.
Calling up data logger mode:
•Press the Store ↓button (STORE will ap-
pear with →STARTor ↑CLEAR →
START displayed).
Starting data logger:
When the display shows →START:
•Start recording data with the Date/Time ↵
button (“BUSY →STOP” will appear in the
display and the measurement begins).
Stopping the data logger:
When the display shows →STOP:
•Stop recording data by pressing the
Date/Time ↵button (↑CLEAR →START
will appear in the display).
Clearing data logger:
When the display shows ↑CLEAR:
•Press the Rate ↑button (MEM.CLEAR? →
YES will appear in the display).
•Confirm by pressing the Date/Time ↵but-
ton.
Exiting data logger mode:
When the display shows ↑CLEAR →START:
•Press the Channel ←button.
9. Use of Ethernet port
In order to connect the 3B NETlog™ unit into a
local network using its Ethernet port, carry out
the following procedure:
9.1 Assignment of an IP address by the
router
