Safety instructions
CX22B-R A04722_02_E00_00 HBM: public 9
The SomatXR series and its modules are intended for use in an industrial envi
ronment. When used in residential or commercial environments, additional
arrangements may be required to limit electromagnetic emissions.
The supply connection, as well as the signal and sense leads, must be
installed in such a way that electromagnetic interference does not adversely
affect device functionality. (HBM recommendation: "Greenline shielding
design," downloadable from the Internet at http://www.hbm.com/greenline.)
The measurement module and devices used in automation equipment must be
covered over in such a way that adequate protection or locking against unin
tentional actuation is provided (e.g. access checks, password protection, etc.).
For those measurement modules operating in networks, safety precautions
must be taken in terms of both hardware and software, so that a line break or
other interruptions to signal transmission do not cause undefined stated or loss
of data in the autmation device.
After making settings and carrying out activities that are password-protected,
ensure that any controls that may be connected remain in a safe condition until
the switching performance of the module has been tested.
An emergency and incident plan must be prepared, decribing the responses to
minimize risk in the event of an emergency or incident. Operating personnel
must be familiar with this plan, which must be accessible to them.
Notice
In the following situations, the module must be shut down and secured to pre
vent inadvertent operation:
-visible signs of damage to the module
-(audibly) loose parts in the module
-the module no longer works
