3D Global SCALEREO User manual

TD_UserManual_FPW_EN Rev. 1.0 / 16.03.2022 Page 1 / 2
3D Global Solutions GmbH
Am Krebsgraben 15 / Geb. 2.2
DE-78048 Villingen-Schwenningen
www.3dgs.eu / [email protected]
Tel: [phone]
UserManual
Wireless Foot Pedal
The FPW (Foot Pedal - Wireless) can be used to control the most important camera features of
your SCALEREO®system, if equipped with an adequate camera module. For details on your
specific SCALEREO®system, please refer to the documentation provided with the system.
1. Commissioning
1.1 Connection
•Connect the small FPW antenna with the
designated socket at the rear side of your
SPU.
1.2 Assigning / deleting a FPW
If the FPW was delivered together with your system, it is already assigned to it.
To delete or reassign a FPW,
•open the menu on your SCALEREO system by using your ControlBar,
•select the tab “Footswitch”,
•press “Add” or Delete” and shortly after tap once briefly any of the pedals of that FPW,
which should be added or deleted.

TD_UserManual_FPW_EN Rev. 1.0 / 16.03.2022 Page 2 / 2
For each of the 3 FPW-pedals, one specific action can be assigned.
Therefor
•select one of the available actions for each FPW-pedal by using the ControlBar,
•confirm the selection with the middle button of the ControlBar.
2. Operation
•The FPW starts automatically when pressing any pedal on the FPW.
•After several minutes of inactivity, the FPW goes to StandBy mode automatically.
•Press the required FPW-pedal formorethan~0,5sec to perform the action you assigned
to it.
•To toggle between “double actions” (as Zoom In/Out), simply tap the button once briefly.
3. Maintanance
•The FPW needs a 9V block battery.
•To replace the battery, open the Battery compartment on the bottom side of the FPW.