A.R.T. Furniture 229155-2608 User manual

ASSEMBLY INSTRUCTIONS
5-0 & 6-6 Poster Bed HB's & FB's with 5/0 - 6/6 Poster Bed RS
229155-2608/229156-2608HB/FB&229155-2608RS
Thank you for purchasing this quality product from A.R.T. Furniture. Be sure to check all
packing material for parts which may have come loose inside the carton during shipment.
Identify and count all parts and compare with the parts list below.
Note: Some furniture is heavy, it is recommended that two people assemble this item to avoid
injury or damage.
05/2015
No. Qt.
A
B
C
D
E
5
16" X 2 3 8" Bolt
5
16" Half Round Washer
5
16" Flat Washer
5
16" Lock Washer
Hardware List
! KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE !
Page 1
STEPS:
1) Attach finial (H) as shown in Diagram 1.
2) Turn one end of each bolt (A) into bed posts. Then attach side rails to
headboard and footboard through the holes, using curved washers (B),
flat washers (C), lock washers (D) and nuts (E). Tighten with wrench (F) as
shown in Diagram 2.
3) Screw support legs (G) into the slats (F) and adjust the height by turning the leveler as shown in
Diagram 3.
4) Place the slats (F) on side rails and fasten with screws (G) as shown in Diagram 4.
Finial
Slat Support
Parts List
Mattress Support Slat
No. Qt.
F
G
H
3
3
4
1
8
12
8
8
8
8
F
G
5
16" Nut
5
16" Wrench
#8 X 1 1
4" Wood Screw

Bottom Post FOOTBOARD
ASSEMBLY INSTRUCTIONS
5/0-6/6 Poster Bed Canopy&5/0 - 6/6 Poster Bed Posts
229155/156-2608CN&229155-2608PS
Thank you for purchasing this quality product from A.R.T. Furniture. Be sure to check all
packing material for parts which may have come loose inside the carton during shipment.
Identify and count all parts and compare with the parts list below.
Note: Some furniture is heavy, it is recommended that two people assemble this item to avoid
injury or damage.
05/2015
No. Qt.
A
B
C
D
E
Parts List
! KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE !
Page 1
STEPS:
1) Attach the bottom post FOOTBOARD (C) on the footboard, as shown in Diagram 1.
2) Attach the upper post (B)on the headboard.
3) Attach the upper post through (B) through the square block FOOTBOARD (D) on the bottom post
FOOTBOARD (C), as shown in Diagram 2.
4) Assemble the canopy side rail (D) and canopy front/back rail (F) using the bolt (G), as shown in
Diagram 3.
5) Assemble the whole canopy and upper post (B) using the finial (A), as shown in Diagram 4.
Finial 4
4
2
2
2
Diagram 1
No. Qt.
G1
4" Bolt
Hardware List 8
Diagram 1 Diagram 2
Diagram 3 Diagram 4
2
F
NOTE: Square block at top of post
(Diagram 2), must be aligned with
the square post of the footboard.