Abocom CAS3047 User manual

- 1-
BroadBand Router
(with 4-Port EtherSwitch)
Quick Installation Guide
M73-APO07-480
STEP 1: CABLING
Figure 1
1-1. Connect the power adapter to this product and power it on.
 The LED of Power will illuminate after this step.
1-2. Apply the UTP cable to connect your Cable/DSL modem to this product’s Internet port.
 The LED of Internet will illuminate after this step.
1-3. Use a network cable to connect your PCs’ Ethernet ports to one of this product’s LAN (1
to 4) ports.
 The LED of LAN port you plugged into will illuminate after this step.
STEP 2: INSTALLING WIZARD
Note: To configure this device, you must have IE 4.01 or above installed.
1. Load the setup CD-ROM onto your computer. The auto-execution file will start
automatically.

2. Select Quick Setup Wizard.
3. The self-explanatory wizard will guide you through the installation procedure. Follow
the on-screen instruction to proceed.
STEP 3: CHECKING THE INTERNET CONNECTION
You can open a new web browser to surf the Internet now.
Should the access fail, you can check by the following steps:
3-1. Go to 192.168.1.254;
3-2. Select Network status\Connection Status in the left pane,
3-3. If the IP address field displays anything except 0.0.0.0, it means the Internet connection is
well established. Otherwise (as illustrated below), repeat the whole procedures.
Figure 3
.
- 2-