
Welcome to your beautiful new, premium quality ceramic aroma
diuser. This unit is ecient to use and simple to maintain. Best of
all it allows you to explore Absolute Essential’s full range of organic,
medicinal quality plant oils with ease. We hope you enjoy!
MAX LINE
AIR OUTLET
TOUCH SENSE BUTTON
COVER
BASE
WATER TANK
WATER SHIELD AIR INTAKE
DC SOCKET
AIR GUIDE HOLE
ELECTRICAL CONTACT
BOARD
ELECTRICAL
CONTACT
AIR GUIDE HOLE
MAIN COMPONENTS:
1. Connect
the DC port to
the DC slot in
the base.
INSTRUCTIONS FOR USE:
2. Place the
water tank on
the centre of
the base.
3. Lift off the
cover using
the guitar
pick tool.
300M L
4. Pour water
into the tank
(no more than
300ml).
5. Add drops
of essential
oil/s (# as per
instructions).
6. Replace
the cover.
7. Connect the AC adaptor to the power socket and switch on. First touch: the unit is
on standby mode with button light. If not touched again within 5 seconds, the unit
will shut off. Second touch: (if touched within 5 seconds of rst touch) continuous
mist with 7 colours changing automatically. Third touch: pause on current LED colour.
Fourth touch: light turns off. Fifth touch: unit turns off.
QUICK TIPS:
•Use measuring cup to ll water tank, don’t ll directly from tap • For optimum running, pour out
the water completely and wipe the unit with a soft cloth after each use (this is particularly important
when switching between different types of essential oils) •It’s normal for ambient humidity and air
temperature to affect the mist density •Do not let the mist spray onto furniture, clothes or walls • If
you’re not using the unit for awhile, make sure it is emptied out completely, cleaned and stored in a
dry place •When rst connected to power the unit is set to OFF •If the unit is running low on water at
any stage it will automatically turn itself OFF.
USING THE REMOTE CONTROL:
CLEANING & MAINTENANCE:
After using 5-6 times (or for 3-4 days), you should clean the unit
out as follows: 1. Take the water tank off the base 2. Completely
empty all remaining water out of the tank (do NOT pour from the
air outlet side, see Fig 1). 3. In a separate bowl, add a few drops
of neutral detergent to warm water. 4. Using a clean, soft cloth
dipped in the detergent solution, wipe out the unit gently but
thoroughly. 5. The water shield can be removed for cleaning (see
Fig 2) but remember to replace it. Do not use harsh chemicals or
alcohol during the cleaning process as this may cause damage.
AIR OUTLET
AIR OUTLET
Fig 1
Fig 2
ON/OFF
Light mode
Light brightness+Light brightness-
Low mist
Timer
Intermittentmist mode
Continuousmist mode
High mist
PULL
ON / OFF
Rotate 7 colours or pause on a
particular colour. Turn on the light
directly without pressing ON/OFF button.
Long press to turn off the light.
There are 7 brightness levels. To
select, make sure it’s in ‘colour pause’
mode, then press light mode button again
then it’s ready to adjust.
HIGH / LOW mist
Long press to cancel the
timing mode with the sound ‘DD’
Continuous / Intermittent mist
mode (run 30sec, stop 30sec).
NOTE: You will need to open the cover and remove the
insulating tape before rst use. If the signal is weak or
not working, you may need to change the battery.
TROUBLESHOOTING:
•IF THE UNIT FAILS TO TURN ON: Check, is there
enough water in the tank? Do you need to rell?
(NB: Do not over-ll. The tank is not designed to
take more than 300ml). Also check, is the power
turned on? You may need to disconnect at the
power outlet, check the cables and re-connect
carefully. •IF THERE IS NO MIST OR AN ABNORMAL
MIST: Check, is there enough water in the tank? Do
you need to rell (no more than 300ml)? Is there
dirt on the ultrasonic atomiser? Refer to Cleaning &
Maintenance instructions to clean the unit.