AccuQuilt A680 User manual

MODEL: A680
ASSEMBLY INSTRUCTIONS
10/24/2018
SCREWDRIVER
NON-LOCK
CASTERS
LOCKING
CASTER
FIGURE #1
1. AFTER OPENING CARTON,
REMOVE INNER CARTON
AND INSTALL CASTERS TO
CABINET AS SHOWN IN
FIGURE #1. GENTLY ROLL
CABINET OVER AND SET
UP ON CASTERS.
INNER CARTON
2. REMOVE CONTENTS FROM
INNER CARTON AND PLACE
ON FLAT WORKING SURFACE.
PLACE RISER TOP WITH
WITH 5MM HOLES FACING UP.
NEXT ATTACH CAM LOCK PINS TO
RISER TOP USING PRE-DRILLED
HOLES. ALIGN HOLES IN RISER
END RAILS WITH CAM LOCK PINS
ON RISER TOP AND SECURE
BY USING A SCREW DRIVER TO
TURN CAM LOCK CLOCKWISE TO
TIGHTEN. AS SHOWN IN FIGURE #2
BELOW.
CAMLOCK
RISER TOP
CAM LOCK PIN
FIGURE #2
RISER SIDE RAIL
BOTTOM RAIL

MODEL: A680
ASSEMBLY INSTRUCTIONS
10/24/2018
2" CONNECTOR BOLT
FIGURE #3
USING THE PROVIDED 2"
CONNECTOR BOLTS, INSERT
THROUGH THE BOTTOM OF
THE DROP LEAF CONNECTING
RISER TO DROPLEAF.
NOTE: RISER CAN BE ATTACHED
TO EITHER DROP LEAF.
3.
DRAWER
ADJUSTABLE
SHELF
RISER DROP LEAF
SUPPORT PANEL
SHELF DEVIDER
DEVIDER SHELF
STATIONARY SHELF