Accurex RX Series User manual

User Manual
RX series Weighing Indicators
Applications: Electronic platform scale, weighing scale, etc.
EN

1
1. Keypad Functions
Off function.
On function and function selection during normal operation and configuration.
Zero display and set zero point or enter a tare value.
A weight is tare and display net weight.
2. Display Status
〖AC〗 Mains power is applied to the indicator.
〖→T←〗 A weight has been tarred and display the net weight.
〖→0←〗 Zero display.
〖◣◢〗 Weight is stable.
×10 The display is temporarily set to high resolution.
lb 〖- 0〗 The unit of weighing is lb.
3. Calibration
Press the key continuously and switch on the device (do not release the
key at any time)
Wait for a short beep and release suddenly.
Let the counting cycle continue and when finished press the key.
〖CAL SP〗 will be displayed.
Press the key.
〖CAL 00〗 will come out.

2
Press the key.
The unit will perform a zeroing operation and the weight to be calibrated will
be displayed (default total capacity - e.g. 60.00)
If you want to change the calibration value, press the key and 0000.00
will appear.
Press until the digit to be modified flashes, then press to modify
it to the desired value (e.g. 10k = 0010.00)
Place the calibration weight on the scale.
Once the weight has been deposited, press the key and the calibration
will be performed and the actual weight will appear.
Calibration completed.
4. A/D Counts Display
Press【ON/*】three times, display〖-A-d-〗, press【→T←】, display〖123456〗, A/D (Digital/Analog)
counts 123456, press the【ON/*】to return to weighing mode.
5. Select Display Mode
In normal weighing status, press【ON/*】for 2 seconds, unit of weighing is lb, press【ON/*】for
2 seconds, unit of weighing is kg.
6. Zero
When the weight is stable, press【→0←】, display〖 0.00〗, zero status LED is turned on. Zero
range is ± 2%FS.

3
7. Tare and Remove Tare
a) Tare: When Tare status LED is off and the weight is ≥0 and stable, press【→T←】 to acquire
tare and switch to net mode, the tare status LED is turned on.
b) Remove tare: When Tare status LED is on, press【→T←】 will switch to gross mode and
removed tare. The tare status LED is off.
8. Battery Capacity
When after turn on indicator, display〖bt 85〗is battery capacity.
9. Low Battery Warning
When the battery is capacity less than 10% of full charge, display will flash. When the battery has
no power, the indictor display〖 bAtt 〗turn off immediately.
10. LED Error Code
Display〖 OUEr〗, weight > FS + 9d, display〖 –OUEr 〗, weight < -2% FS, Display〖 Error〗,
calibration error.

4

5
05/07112021
Gram Precision S.L.
Travesía Industrial, 11 · 08907 Hospitalet de Llobregat · Barcelona (Spain)
Tel. [phone] · [phone]
Fax [phone]
[e-mail]
www.gram-group.com