Acuity Brands JUNO TF23 User manual

INSTALLATION
INSTRUCTIONS
WARNING: MAKE SURE POWER IS OFF BEFORE ASSEMBLY
1. Read all instructions before beginning installation.
2. Do not conceal or extend trac through a building wall.
3. Do not install this system in damp or wet locations.
4. To reduce the risk of fire and burns, do not install this lighting
system where the exposed trac conductors can be shorted or
contact any conductive material.
5. To reduce the risk of fire or overheating, make sure all connections
are tight.
6. Do not install any luminaire closer than 6 inches (15.25 cm) from
any curtain or similar combustible materials.
7. Turn off the electrical power before modifying the lighting system
in any way.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
1 of 2
1300 S. Wolf Road • Des Plaines, IL 60018 • Phone [phone]
Visit us at www.acuitybrands.com/juno-trac
©2017 Acuity Brands Lighting, Inc. Rev 3/17 P3003

1. Ensure that trac sections are fully seated against center ribs
while tightening screws that join connector halves together.
2. For mechanical only connection, remove both electrical contacts
prior to installing trac.
TF23 Straight Connector
INSTALLATION
INSTRUCTIONS
2 of 2
1300 S. Wolf Road • Des Plaines, IL 60018 • Phone [phone]
Visit us at www.acuitybrands.com/juno-trac
©2017 Acuity Brands Lighting, Inc. Rev 3/17 P3003