Adam HUDSON User manual

CO9124 V1_010512
USE & CARE MANUAL
HUDSON ELECTRIC STOVE
LED
www.adamfires.co.uk

02
SECTION 01
These notes must be read before installation
These instructions are for your safety. Please read through them thoroughly
before use and retain for future reference. Failure to follow them could cause
injury and/or property damage.
Note: This manual applies for a number of different products. Please make
sure you follow the appropriate product guide lines.
CONTENTS
SECTION 01
Cautions 03-04
Introduction 05
Handling 05
Unpacking 05
SECTION 02
Tools required 06
Identification 06
Parts supplied 06
Fixings pack 06
SECTION 03
Installation 07
Use 07
Care 07
Specification 08
Guarantee 12
Contacts 12

03
SECTION 01
CAUTIONS
DO’S
• Always install the stove in accordance with this guide. If in doubt obtain
expert advice.
• Always make sure the electrical socket is accessible and located adjacent
to, but not above the stove.
• Always disconnect the stove from the electrical supply before carrying out
cleaning or maintenance.
• Always assemble the stove in accordance with this guide. If in doubt, obtain
expert advice.
• Always ensure the product is assembled in an area that is free from dust,
grease or liquids.
DON’TS
• Never leave children unsupervised in a room where the stove is ON and
unguarded.
• Never obstruct or cover the fan outlet or force items into fire openings.
• Never install or use the stove anywhere where water is in use, i.e. Bathrooms,
Kitchens, Shower Rooms, and Swimming Pool etc.
• Never use aerosols or steam cleaners on or around the stove.
• Never route the mains supply cord under carpet etc.
• Never install the stove close to curtains or combustible materials.
• Never use the stove to dry clothes etc.
• Never sit or stand on the stove.
• Never lean or put weight on the stove.
• Do not use outdoors.
• Do not position furniture, curtains or other combustible material closer than
1 metre from the heater.
• Do not site the stove on deep pile carpets or rugs.
• Never cut off the plug and hard wire into a fixed fused spur

04
SECTION 01
PLEASE DO NOT OBSTRUCT THE AIR VENTS OF THE ELECTRIC STOVE
This appliance has a ‘self resetting’ safety cut out system. To prevent overheating,
ensure the air inlets and outlets are not obstructed. If the safety cut-out operates,
switch off the electric fire and allow to fully cool down. Remove any obstruction
before re-use.
IMPORTANT ELECTRICAL SAFETY
The stove must not be located under an electrical socket; the socket must always be
accessible in order to disconnect the heater from the electrical supply for
maintenance and cleaning. Never cut off the plug and hard wire into a fixed fused
spur.
IMPORTANT!
• Do not spray liquids directly onto any surface of the unit.
• This stove must be earthed. The supply cord must be safely routed from the
fire to an electrical socket.
• If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have had supervision or instruction concerning use of
the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the
appliance.
• The plug must be accessible after installation to allow for isolation in an
emergency.
Warning: In order to avoid overheating, DO NOT COVER THE HEATER
Note: Any new wiring required, must be In accordance with local and national
codes and other applicable regulations in order to reduce the risk of fire, electric
shock, or other injuries.
Note: When the stove is turned on for the first time or when it has not been used for
some time, it may release a slight, harmless odour. This odour is a normal
occurrence caused by the initial heating of the internal heating elements and
will disappear with use

05
SECTION 01
INTRODUCTION
Thank you for choosing this Electric Stove. The product is designed to meet the most
stringent quality, performance, and safety requirements. This guide aims to improve
your understanding and appreciation of your new product by providing simple and
informative assembly instructions.
HANDLING
Before continuing any further with the installation of this stove please read the
following:
• When lifting always keep your back straight. Bend your legs and not your back.
• Avoid twisting at the waist. It is better to reposition your feet.
• Avoid upper body / top heavy bending. Always bend from the knees rather than
the waist.
• Do not lean forward or sideways whilst handling the fire.
• Always grip with the palm of the hand. Do not use the tips of fingers for support.
• Always keep the product as close to the body as possible. This will prevent
unnecessary and undue strain on the body.
• Use gloves to provide additional grip.
• Always use assistance if required.
UNPACKING
The unit is supplied in a single package carton. Carefully unpack the product using
the following procedure:
• Carefully lift the stove out of the box
• Carefully remove the protective packaging and bag from the stove
• Carefully remove the protective film covering the stove

06
SECTION 02
TOOLS REQUIRED
No tools are required for the installation of this product.
IDENTIFICATION
(Image for illustrative purposes only)
PARTS SUPPLIED
This product comes as one fully assembled unit.
(if you require spares or replacement parts for your product please see the contact
details on the last page of this manual)
FIXINGS PACK
No fixings pack is required for the installation of this product
Heater
Switches

07
SECTION 03
INSTALLATION
Please ensure the wall and floor are flat before installing this stove into a surround or
hearth.
USE
The appliance is controlled using 4 switches, located on the side of the stove. Use the
following sequence to operate. The grey represents a ‘pressed switch.’ A switch is in
the ON position when the side with the markings on (e.g. I or II) is 'pressed in’.
On/Off
with Effect
only
Cool Air
Blow &
Effect
1kW Heat
setting 2kW Heat setting
CARE
• The stove can be cleaned using a damp cloth.
• If the supply cord is damaged, it must be replaced by a suitably qualified person.
• The area around the stove should be kept free from animal hair, lint and other
extraneous material that may be drawn into the workings of the appliance
which could affect its performance.

08
SECTION 03
PLUG REPLACEMENT
(for Product fitted with BS plug)
This appliance is supplied with a BS1363 3 pin plug fitted with a 13 Amp fuse. Should
the fuse require replacement, it must be replaced with a fuse rated at 13 Amp and
approved to BS1362.
In the event the mains plug has to be removed/replaced for any reason, please
note:
The wires in the mains lead on this appliance are coloured in accordance with the
following code:
THIS APPLIANCE MUST BE EARTHED
As the colours may not correspond with the markings identifying the terminals in your
plug proceed as follows.
• The green and yellow earth wire must be connected to the terminal in the plug
which is marked with the letter E or with the earth symbol
• The blue wire must be connected to the terminal marked N
• The brown wire must be connected to the terminal marked L
Important - any cut off plug should be disposed of safely to prevent hazard. There is
a danger of electric shock if a cut off plug is inserted into a socket outlet.
SPECIFICATION
Supply Voltage - 220-240V~50Hz
Rated Power - 2000W
Fuse Rating - 13 Amp
Lighting - 5W LED Array (non serviceable)
Class - 1
Dimensions (cm) - H54.6 x W41.0 x D31.0
Weight - 14.5kg
Earth
Neutral
Live
Green and Yellow -
Blue -
Brown -

09
SECTION 01
CONFORMITY WITH DIRECTIVES
Conforms with relevant European Directives
ENVIRONMENTAL PROTECTION
• (WEEE) Waste Electrical and Electronic Equipment
Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your Local Authority or retailer for recycling
advice.
• This appliance complies with the RoHS directive which restricts the use of certain
hazardous substances in electrical and electronic equipment.
This directive bans the placing on the EU market of new electrical and electronic
equipment containing more than agreed levels of lead, cadmium, mercury,
exavalent chromium, polybrominated biphenyl (PBB) and polybrominated diphenyl
ether (PBDE) flame retardants.

12
SECTION 03
www.firedupgroup.co.uk
Fired Up Corporation Ltd.
Fired Up Buildings
St Thomas Road
Huddersfield
HD1 3LF
United Kingdom
C
PART OF
GUARANTEE
For your convenience, you are not required to complete a form and return it to us in
order to validate your guarantee. However, please ensure that you retain your
receipt which will act as both proof of purchase and a guarantee validation
document. We recommend that you attach your receipt to this documentation.
Your product carries a 12 month guarantee from the date that the original purchaser
receives it. If your product fails to operate to its specification due to faulty
workmanship or materials during the guarantee period, we will either repair or
replace the product. We will use our discretion to determine whether to offer a
repair or provide a replacement. The product will not be covered by the guarantee
if it has been misused, transformed, modified or altered in any way.
If your product fails within the guarantee period please ensure that you have all
necessary documentation available including proof or purchase (receipt or invoice
with serial number, location and date of purchase) in addition to all original
undamaged packaging and leaflets etc. It is strongly recommended that you
inspect your product carefully before it is used or installed. For full details of your
product you should refer to the instruction manual which accompanies the product.
You are strongly advised to read this manual carefully in its entirety and to retain it for
future reference.
This product guarantee does not affect your statutory rights.
CUSTOMER HELPLINE
08448 809 301
[email protected]
AFFIX RECEIPT OR PROOF
OF PURCHASE HERE