adapt 4814109 User manual

ITEM
1
2
3
4
5
6
QTY
1
1 Left, 1 Right
1 Front, 1 Rear
1
4
8
PART NUMBER
-
SS-20.1085 (LH) SS-20.1086 (RH)
SS-20.1114 (FR) SS-20.1115 (RR)
SS-20.1092
SS-10.1030
SS-10.1029
REQUIRED TOOLS (not included)
Drill
1/16” Drill bit
Phillips Screwdriver
Pencil
DESCRIPTION
Wire Rack
Slide
Bin Wire
Trash Bin
Rack Screw
Slide Screw
1
4
2
5
3
6
PARTS LIST
NOTE: Item #5 is small and
packed with Item #6
▪ READ ALL INSTRUCTIONS AND CHECK PARTS BEFORE STARTING INSTALLATION
▪ RETAIN ALL PACKING MATERIALS UNTIL INSTALLATION IS COMPLETE
IMPORTANT
MODEL
Minimum
Height (a)
H
Minimum
Depth
D
Minimum
Opening
A
28 Quart 18” 19” 11”
(a) Excludes any items that might be
placed in the Trash Bin.
For best access to Trash Bin avoid
installing drawers immediately above
unit in standard height cabinets.
H
A
DD
H
A
Face-Frame Frameless
DO NOT RETURN TO THE RETAILER
If you have any questions, please contact Customer Care at
1-800-721-4191
Monday – Friday 8-5 Central Time
4814109 - MEN0632 28 Qt Soft Close Trash Bin

Page 2 - Revision 03
Attach Wire Rack to Slides using
Rack Screws.
Locate the assembly in the cabinet.
NOTE: The front of the Slides should
be at least 1-1/2”back from the
front of the cabinet.
NOTE: For a face-frame cabinet,
make sure the assembly is located
far enough from the cabinet side
walls as to not strike the face-frame
during operation.
Using a pencil, mark the location of
two mounting holes in each of the
brackets on the Slides.
Remove the assembly from the
cabinet. Drill 1/16” pilot holes
in each location marked in the
cabinet.
STEP 1
STEP 2
STEP 3
STEP 4
MOUNTING INSTRUCTIONS

Page 3 - Revision 03
Finger Loop
Replace the assembly in the cabinet
and attach the Slides to the
cabinet bottom using eight of the
Slide Screws.
NOTE: It may be necessary to
remove the Wire Rack from the
Slides in order to properly drive in
the Slide Screws.
Slide the Wire Rack out of the
cabinet. Insert the Bin Wires into
the tubes on the Wire Rack.
NOTE: The Bin Wire with the nger
loop should be placed at the front
of the Wire Rack.
Place the Trash Bin into place.
STEP 5
STEP 6