Adaptec DuoConnect AUA-3121 User manual

R
Adaptec AUA-3121
DuoConnect Adapter
Installation Guide

1
This Guide describes how to install the Adaptec DuoConnect AUA-3121
adapter in a Windows computer.
Kit Contents
■DuoConnect adapter
■FireWire cable (6-foot/1.8 meter, 6-to-4-pin FireWire cable used to
connect digital video cameras)
■Printed Adaptec DuoConnect Installation Guide
■DuoConnect CD containing:
■This User’s Guide
■Adobe Acrobat Reader software
■Drivers
■Readme file
■Registration card
■Video editing software
The User’s Guide on the CD provides more detailed instructions on
installing the adapter, including driver installation instructions and
troubleshooting tips. In addition, the User’s Guide provides Technical
Support, and Warranty information for your adapter.

2
System Requirements
In order to use the DuoConnect adapter, you need
■One of the following types of computers:
■Windows 2000, Windows Me, or Windows 98 SE computer with a
200-MHz (or faster) processor
■Power Macintosh Beige G3, Rev. B or newer, with Macintosh
OS 9.0.4 and later
Note: The DuoConnect adapter is not compatible with blue and
white G3s. For the latest information on operating system support,
see the Readme file on the CD or check the Adaptec Web site at
http://www.adaptec.com.
■An available PCI slot (32-bit or 64-bit, 3.3-volt or 5-volt, 33-MHz and
66-MHz)
■A CD-ROM drive

3
Installing the DuoConnect Adapter
To install the DuoConnect adapter in a computer, follow these
instructions:
1Discharge any static electricity from your body by touching a
grounded metal object (such as the exposed metal parts on the back
of your computer) before handling the DuoConnect adapter.
2Turn off power to the computer and disconnect the power cord.
3Open the computer cabinet. See your computer documentation for
specific instructions, if needed.
4 Locate an unused 32- or 64-bit PCI expansion slot and remove the
expansion slot cover. Save the slot cover screw, if any, for use in Step 5 .
64-bit PCI slot
32-bit PCI slot
Expansion
slot cover
Slot cover
screw

4
5Insert the DuoConnect adapter in the PCI expansion slot. Press the
adapter firmly into the slot until it clicks into place. Replace the slot
cover screw. When installed properly, the adapter should be level
with the expansion slot, as shown below.

5
6Connect the DuoConnect adapter internal power connector to a
spare 4-pin mini power connector (similar to the connector on a
floppy drive), as shown below. This connector supplies optional bus
power to the 1394 ports. If your system does not have a spare power
connector, you can buy one at most computer and electronics stores.
Check www.adaptec.com for more information.
7Close the computer cabinet and reattach the power cord.
System power connector
Adapter power connector

R
Adaptec, Inc.
691 South Milpitas Boulevard
Milpitas, CA 95035 USA
© 2001-2002 Adaptec,Inc.
All rights reserved. Adaptec and the Adaptec logo
are trademarks of Adaptec, Inc. which may be
registered in some jurisdictions.
Part Number: 512924-06, Ver. ACLB 01/02