ADDON NWP200 User manual

NWP200
ADD-NWP200 Quick Installation Guide
802.11N/Draft
Wireless PCI Adapter
Insert the Wireless PCI Adapter into your
computer before you power on your
computer.
This quick installation is meant to help you to
install the product quickly and easily. For
further information, please refer to the user’s
manual.
- One Wireless PCI Adapter - One CD-ROM includes driver, utility and user’s manual
- One Quick Installation Guide
1.Install driver and utility for Windows Vista
1.1 The Found New Hardware Wizard below will
appear after the PCI adapter installed. Please
click Cancel to continue.
1.2 Insert Installation CD into CD-ROM drive,
windows below will apear. Click Install Driver
& Utility to begin device driver installation.
1.3 Please read the following license agreement.
Use the scroll bar to view the rest of this
agreement. Select I accept the terms of the
license agreement and click Next to continue.
1.4 Click Install to begin the installation.
Blinking Data is being transmitted or received.

1.5 Please wait for a while during the adapter is
configuring your new software installation.
1.6 After the setup wizard has successfully
installed wireless LAN, click Finish to exit the
wizard.
1.7 To check if the adapter is properly installed,
you can right-click My Computer > choose
Properties > click Device Manager.
1.8 The Configuration Utility appears as an icon
on the system tray of Windows while the
adapter is running. You can open the utility
by double-click on the icon.
For any further information about how to use
this utility, please refer to your user’s manual.
1.9 ADDON wireless utility needs to cooperate with
Microsoft AutoConfig service in order to perform
scanning and connecting actions, so the
AutoConfig service should be enable
beforehand.

2.1 The Found New Hardware Wizard below will
appear after the PCI adapter is installed.
Please click Cancel to continue.
2.2 Insert Installation CD into CD-ROM drive,
windows below will appear. Click Install
Driver & Utility to begin device driver
installation.
2.3 Please read the following license agreement.
Use the scroll bar to view the rest of this
agreement. Select I accept the terms of the
license agreement and click Next to continue.
2.4 In Windows XP, there is a Windows Zero
Configuration Tool for you to setup wireless
adapter. You can choose to configure the
adapter through the Microsoft Zero
Configuration Tool or the Configuration
Tool. It is recommended to choose the
Configuration Tool for the adapter. Click
Next to continue.
2.5 If you need the adapter to operate with better
performance, place choose Optimize for
performance mode to enable the Tx Burst
mode. Or you can choose Optimize for WiFi
mode to run in standard wireless network.
2.Install driver and utility for Windows XP
2.6 Click Install to begin the installation.

2.7 Please wait for a while during the adapter is
configuring your new software installation.
2.9 To check if the adapter is properly installed,
you can right-click My Computer > choose
Properties > click Device Manager.
2.8 After the setup wizard has successfully
installed wireless LAN, click Finish to exit the
wizard.
2.10 The Configuration Utility appears as an icon
on the system tray of Windows while the
adapter is running. You can open the utility by
double-click on the icon.
For any further information about how to use
the utility, please refer to your user’s manual.