Addonics Technologies R1825SN-2MS User manual

CONTACT US
Technical Support
If you need any assistance to get your unit functioning properly, please have your
product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: [phone]
Email: http://www.addonics.com/support/query/
www.addonics.com
Phone: [phone]
Fax: [phone]
Email: http://www.addonics.com/sales/query/
1U Rack for 2.5" HDD/SSD, 2 SFF-8088
connectors
(R1825SN-2MS)

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phoner: 408-453-6212 Email. www. Addonics.com/support/query/
Installation
1. Unlatch the drive bay door by pushing the rectangular button on the door to the right.
The Eject lever should swing open.
2. Insert a drive into each bay as desired, SATA connectors first, label side up, push the
drive into the bay. Do not force the drive in if you feel resistance.
3. Close the drive bay door till it is latch securely.
4. Connect two Mini SAS cables between the back of the 1U Rack and a computer.
5. Make sure the AC input switch is set correctly, then connect the power cord to
an AC outlet.
6. Turn on the 1U Rack by switching the AC power switch on the rear to ON,
To remove a drive, unlatch the drive bay as described in step 1 above and pull the Eject
Lever until the drive disengages from the internal connector then pull the drive out.
Hot Swapping drives
The R1825SN-MS unit supports hot swapping (inserting or removing drives while the
drives are running and connected to a computer). The controller on the
computer must also support hot swapping - be sure to confirm this before
attempting to insert or remove drives while the system is running. Also be sure to
practice the appropriate safe removal procedure before proceeding. Failure to practice
safe removal procedures will result in loss or corruption of data.
Unpacking and overview
WARNING: Please remember to
set the power supply to your local
outlet voltage prior to plugging in
the power cord. Failure to do so
may damage the power supply.