ADEMCO 7825 User manual

N7651 2/95
Nom 7825
OUTDOOR ANTENNA
WITH BRACKET
INSTALLATION INSTRUCTIONS
The No. 7825 Outdoor Antenna with Bracket is intended for general outdoor use with Ademco Long Range Radio
products.
It includes awall/Dole mountirm bracket, and a connector cable assemblv with weather-resistant protective rubber
boot. Screws and” anchors for fiall mounting are provided.
h
t~VERTICAL
MAXIMUM METAL
PIPE OR SURFACE
Figure 1identifies
the various parts
of the 7825
HEIGHT >JL
r1
‘i I
PIPE/POLE 5-314”
cI
9-518”
AITACH RUBBER BOOT
TO THIS CYLINDER
NCONNECTOR
.,
‘i \\. li \[
~&SLOTS “A (3)
FOR WALIJFLOOR
—AwB~
\
BRACKET MOUNTING
BA
\SLOTS “B”(4) FOR pc)LE/plFIEMOUNTING
‘(USE TWO 2-’1/4” U-BOLTS)
Figure 1
+The unit may be mounted in several ways, but it must be
mounted vefiically.
1)
2)
3)
The bracket may be mounted to awall, by using the
#1Oscrews and wall anchors provided. Slots “A” (see
Figure 1) should be used.
Figure 2shows it mounted to apole or pipe with
two 2-1/4” U-Bolts (not provided). Slots “B” (see
Figure 1) should be used. Be sure that the pole/pipe
does not extend above the base of the antenna.
An optional No. 7825MB Floor Mount Bracket is
available and is shown and described in Figure 3.
Figure 2

+OPTIONAL N0.7825MB FLOOR MOUNT BRACKET
1) Secure the bracket to the floor with 3screws. Use the three 3/4”
screws and anchors provided with the 7825, or other fasteners as
required.
2) Attach the 7825 assembly (via its slots “A”) to the bracket’s
holes “A”. Use the three 1/2” stainless steel screws provided with
the bracket.
Figure 3PUSH THIS END OVER OUTSIDE OF 3“ DIAMETER
CYLINDER UNDER MAIN ASSEMBLY
\
AFTER MOUNTING THE
2)
3)
4)
MAIN ASSEMBLY:
1) Push the Nconnector cable assembly
through the rubber boot in the direction
shown in Figure 4.
See Figure 1
Connect the cable to the Nconnector at
the bottom of the unit.
Wire tie the cable to awire tie point so as
to forma drip loop.
Push the end of the rubber boot over the
3“ diameter cylinder at the bottom of the
unit.
Y
UGH
Figure 4
REFER TO THE INSTRUCTIONS FOR THE EQUIPMENT WITH WHICH THIS
DEVICE IS USED, FOR WARRANTY INFORMATION, AND FOR DETAILS
REGARDING THE LIMITATIONS OF THE ENTIRE ALARM SYSTEM.
N7651 .2/95
ALARM DEVICE MANUFACTURING COMPANY.
ADIVISION OF PlllWAY CORP.
165 EILEEN WAY, SYOSSET, NY 11791
COPYRIGHT @1995 PITTWAY CORPORATION