Belden Hirschmann BAT-ANT-N-14G-IP23 User guide

Mounting Instruction
Release 02 06/10
Technical Support
[email protected]
Mounting Instruction
Directional antenna for 2.4 GHz with 14 dBi gain
BAT-ANT-N-14G-IP23
Safety instructions
General instructions
If exposed to extreme environmental conditions, especially icy conditions
or a polluted atmosphere, the connectors should be covered with a self-
vulcanizing tape or a cold shrink tube.
Disclaimer
All pertinent country, state, regional, and local safety regulations must be
observed when installing and using this product. For reasons of safety
and to help ensure compliance with documented system data, only the
manufacturer should perform repairs to components. This equipment
must only be installed and serviced by qualified personnel.
WARNING
ELECTRIC SHOCK OR FALLING
Avoid mounting the antenna near power lines.
When installing an antenna from a ladder or elevating equipment, take
precautions to avoid falling and ensure the equipment is securely positioned
on solid ground.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.

2Mounting Instruction
Release 02 06/10
Pole/flat surface mounting
Note: For pole mounting, use a tightening torque of 35.4 lb in / 4 Nm.
Figure 1: Pole/flat surface mounting

Mounting Instruction
Release 02 06/10 3
Mounting with down-tilt bracket
Figure 2: Mounting with down-tilt bracket
Mounting with side-tilt bracket
Figure 3: Mounting with side-tilt bracket

4Mounting Instruction
Release 02 06/10