ADEMCO 744 User manual

7
No. 744
N5746 1191
‘kLPEMC0,
MULTI-TONE SIREN DRIVER
INSTALLATION INSTRUCTIONS
FmtLlm=
l High output.
l Separate Burghy and Fire Alarm sounds.
l Operaws on 12VDC. l Programmabletype of sound.
l Compatiblewith Ademco 4-16 ohm speakers.
l Smallcompact size for easy mounting
l Powers m combinationsof speakars usingdouble-faced tape - measures only
(series, pamYe I,or seties-parallel). 2-516’x 4’ x 3l4’.
Sound Selection
The driver pan be programmed for h desired alarmsound,as indiited below.
SOUND SELECTlON
Jumper Plug Poaftion FIRE - BURGLARY
,
NO JUMPER PLUG Electronic‘Bell’ Warble
POSlTlON 1(across pins 18 2) Slow Ramp Britishw&one
POSITION2 (acrosspins2 63) FastWarble Fast Dual tone
POSITION3 (acrosspins 3 8 4) Same as position2
POSITION4*(across pins 4 & 5) Warble 1Warble
l If bluejumper (saa Fii.1) iscut with plug in position4, an output similar boAdemco
No. 733 Siren Driverwill be produced- Warbw for BURG, Steady’ for FIRE.
WARBLE TONE OUTPUT: 119dB
(at 1meter)
STEADY TONE OUTPUT: 116dB
(at 1meter)
.. With Ademco No. 713,8 ohm,
30W Speaker
Drhrer Current Consumption”
With 4 ohm spaaker load: 2.5 amps.
Wth 8 ohm speaker load: 1.3 amps..
With 16ohm speaker load:0.9 amps.
-At 12V DC I
Wiring Connection* Figure 1. Siren Driver Board
@ SPEAKER - To siran speaker(s).See Fqurrr 2.
@ SPEAKER - To siren speaker(s).See Fgure 2.
@ GND -To ground terminal on control.
@ FIRE -To Fire alarm ralayt (N.O. term) on control(connectoontrol’sCOM terminal to 12V+).
@ BURG -To Burglaryalarm relayt (N.O. term).oncontrol (connectconf&s COM terminal to
12v+.
’ If control has only one alarm relay, connect its N-0. relay output terminal to either FIRE or
BURG terminals on the driver board. Available chokes of sound output will then be restricted
to those listed under FIRE or BURGLARYin thetable above, dependingon your connection.
UWORtANT: 1. Do not use the No, 744 in conjunctionwith an external bell.
2. Ademco recommendsthat the No.744 be mountedin the control cabinet, not
remotely. (CONT’D OVER)
www.PDF-Zoo.com

2 speakers
16 ohm
Load
4 Speakers
8 ohm
2 speakers
4 ohm
Figure 2 Typical Multiple Speaker Configurations (using Ademco No. 713)
F-7
LIMIIED WARRANTY
Alarm Device Manufacturing Company, a Division of Pittway Corporation, and its divisions,
subsidiaries and affiliates (‘SelleT), 165 Eileen Way, Syosset, New York 11781, warrants its
products to be in conformance with its own plans and specificationsand to be free from defects in
materiels and workmanship under normal use and.service for 18 months from the date stamp
control on the productor, for productsnot having an Ademco date stamp, for 12 months from date
of original purchase unless the installation instructions or catalog sets forth a shorter period, in
which case the shorter period shall apply. Seller’s obligation shall be limited to repairing or
replacing, at its option, free of charge for materials or labor, any part which is proved not in
compliance with Seller’s specifications or proves defective in materials or workmanship under
normal use and se&e. Seller shall have no obligation under this Limited Warranty or otherwise if
the product is altered or impruperfy repaired or serviced by anyone other than Ademco factory
service. For wananty senrice, return product transportation prepaid, to Ademco Factory Service,
165 EileenWay, Syosset, New York 11791.
, THERE ARE NO WARRANTIES, EXPRESS OR IMPLIED, OF MERCHANTABILITY. OR
FITNESS FOR A PARTlCULAR PURPOSE OR OTHERWISE, WHICH EXTEND BEYOND THE
DESCRlPTlON ON THE FACE HEREOF. IN NO CASESHALL SELLER BE UABLE TO ANYONE
FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF THIS OR ANY
OTHER WARRANTY. EXPRESS OR IMPLIED, OR UPON ANY OTHER BASIS OF UABILITY
WHATSOEVER, EVEN IF THE LOSS OR DAMAGE IS CAUSED BY THE SELLERS OWN
NEGLIGENCE OR FAULT.
Seller does not represent that its product may not be compromised or circumvented; that the
product will prevent any personal injury or property loss by burglary, robbery, fire or otherwise; or
that the product will in all cases provide adequate warning or protection. Buyer understands that a
properly installed and maintained alarm may only reduce the risk of a burglary, robbery or fire
without warning, but it is not insurance or a guarantee that such will not occur or that them will be
no personal injury or property loss as a result. CONSEQUENTLY, SELLER SHALL HAVE NO
LIABILITY FOR ANY PERSONAL INJURY. PROPERTY DAMAGE OR OTHER LOSS BASEDON
A CLAIM THE PRODUCT FAILED TO GIVE WARNING. However, if Seller is held liable, whether
directly or indirectly, for any loss or damage arising under this Limited Warranty or otherwise,
regardless of oause or origin, Seller’s maximum liability shall not in any case exceed the purchase
price of the product, which shall be the complete and exclusive remedy against Seller. This
warranty replaces any previous warranties and is the only warranty made by Seller on this product.
No increase or alteration,written or verbal, of the obligation of this LimitedWarranty is authorized.
-,
;
%DEMCO,
ALARM DEVICE MANUFACTURING CO.
A DIVISION OF PlTlWAV CORPORATION
165 Eileen Way, Syosset, New York 11791
Copyrtght 0 1991 PITTWAY CORPORATION
N5746 119
1
.-,
www.PDF-Zoo.com