
IMPORTANT SAFETY PRECAUTIONS
READ AND SAVE THESE
INSTRUCTIONS CAUTION:
For residential use only. Do not use to exhaust hazardous or explosive materials and/or vapors.
CAUTION:
Range hood may have very sharp edges; please wear protective gloves when installing, cleaning or
servicing the unit.
This appliance must be installed by a qualified technician. The manufacturer declines all
responsibility in case of failure to adhere to safety standards. Install this hood in accordance with
all the specified requirements.
WARNING
To reduce the risk of fire, electric shock or injury to persons, observe the following:
manufacturer.
All other servicing should be referred to a qualified technician.
CAUTION:
To reduce risk of fire and to properly exhaust air, be sure to duct air outside - do not vent exhaust air into
spaces within walls, ceilings, attics, crawl spaces, or garages.
Automatically operated device - to reduce risk of injury disconnect from power supply before servicing.
Before servicing or cleaning the unit, switch power off at the service panel and lock the service
disconnecting means stop revent power from being switched on accidentally. If the service
disconnecting means cannot be locked, securely fasten a noticeable warning device, such a tag,
to the service panel.
Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the
Follow the heating equipment manufacturer's guide line and safety standards such as those published
by the National Fire Protection Association (NFPA) and the local code authorities.
equipment to preventback-drafting.
Do not make alterations to the original wiring.
Do not attempt to repair or replace any part of your hood unless it is specifically recommended in this
manual.
Sufficientairisneededforpropercombustionandexhaustingofgasesthroughthechimneyoffuelburning
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
Ducted fans must always be vented to the outdoors.
Installation work and electrical wiring must be done by a qualified person in accordance with all
applicalbe codes & standards, including Fire-rated construction.
4