Advantech PPC-L157 Series User manual
PPC-L157 Series Desktop
Stand
Setup
Guide
The
PPC-L157
series
of
products
customized
stand
is
suitable
for
desktops
and
other
horizontal
locations.
A
unique
spring
inside
the
stand
enables
the
panel
PC’s
vertical
tilt
to
be
adjusted
about
30
degrees.
Your
desktop
stand
package
should
contain
one
of
each
of
the
following:
●
main
body
●
holding
plate
●
base
●
top
cover
●
rear
cover
●
packet
of
screws
Follow
these
procedures
to
set
up
the
stand:
1.
Attach
the
holding
plate
to
the
rear
cover
of
the
panel
PC,
using
the
four
M4
x
12L
round-head
screws
provided.
(Refer
to
the
illustration
below.)
2.
Attach
the
arms
of
the
main
body
of
the
stand
to
the
rear
cover
of
the
panel
PC,
using
the
four
M4
x
8L
flat-
head
screws
provided.
3.
Slide
the
main
body
of
the
stand
into
the
stand
base.
The
bottom
plates
of
the
main
body
should
slide
perfectly
over
the
back
plate
of
the
base.
Fasten
the
main
body
to
the
base
with
the
two
M4
x
8L
flat-head
screws
provided.
4.
Attach
the
rear
cover
of
the
stand
to
the
main
body
of
the
stand
by
snapping
the
lugs
of
the
rear
cover
into
the
slots
of
the
main
body.
When
the
rear
cover
locks
into
place,
you
will
hear
a
click.
5.
Attach
the
top
cover
by
snapping
the
lugs
of
the
top
cover
into
the
slots
of
the
holding
plate.
The
cover
must
be
rotated
as
it
is
snapped
into
place.
When
the
top
cover
locksinto
place,
you
will
hear
a
click.
200KL15700
1st
Edition,
Printed
in
China,
Sep,
2009
Table of contents
Other Advantech Rack & Stand manuals
