Advantech PPC Series User manual

1 PPC-STAND-A1E User Guide 202KSTAN01
PPC Series Stand
PPC-STAND-A1E
User Guide
USER GUIDE
Packing List
Item Name Qty. Pic. Item Name Qty. Pic.
AScrew
(M4x8L)
12
(4 x spare) BScrew (M4x6L)
6
(2 x spare)
CScrew
(M4x5L)
2
(1 x spare) 1 Hinge 1
2VESA
Bracket 1 3 Hinge Cover 1
4 Base Plate 1
IMPORTANT Base Plate Adjustment
Consider the thickness of your PC when adjusting the feet
of the stand.
If your PPC panel PC has a thickness of less than 80 mm,
leave the feet in Position 1 (default).
If your PPC panel PC has a thickness of more than 80 mm,
loosen the two screws highlighted in red in the image to the
right and adjust the position of the feet to Position 2. Once
the feet are in the correct position, tighten the two screws.
Note: If the PPC panel PC’s thickness is more than 125 mm,
this stand CANNOT reliably hold the PC.

User Guide 2
USER GUIDE
Installation Guide
Step 1: Use 4 x screws (Item A) to secure the VESA
bracket (Item 2) to the rear of the panel PC. Users can
choose between a 75x75 mm or 100x100 mm VESA
mount according to their application needs.
Step 2: Use 4 x screws (Item A) to secure the base plate
(Item 4) to the hinge (Item 1).
Step 3: Use 4 x screws (Item B) to secure the hinge (Item
1) to the VESA bracket (Item 2).
Step 4: Use 1 x screw (Item C) to secure the hinge cover
(Item 3) to the VESA bracket (Item 2).
The assembled PPC series stand with PPC panel PC
should appear as shown below.