AEM P/N 30-2207 User manual

P/N 30-2207
GPS MODULE
AEM Performance Electronics, 2205 126th Street Unit A, Hawthorne, CA 90250 - Phone:(310) 484-2322
http://www.aemelectronics.com
STOP! - READ THIS BEFORE INSTALL OR USE!
WARNING:
THIS INSTALLATIONMAY REQUIREWELDING OR INTEGRATIONINTO A VEHICLE'S ELECTRICAL SYSTEM. DAMAGE
TO SENSITIVEELECTRONICS, FIRE, OREXPLOSIONMAY OCCURIF PROPERPRECAUTIONIS NOTTAKEN. IF THERE
IS ANY DOUBT, DO NOT ATTEMPT THEINSTALLATIONANDCONSULTA PROFESSIONAL.
NOTE: IT IS THERESPONSIBILITY OFTHEENGINETUNER TO ULTIMATELY CONFIRMTHECALIBRATIONUSEFOR
ANY PARTICULARENGINEIS SAFEFORITS INTENDEDUSE. AEMHOLDS NO RESPONSIBILITY FORANY ENGINE
DAMAGETHATRESULTS FROMTHEMISUSEOFTHIS PRODUCT.
Instruction
Manual
The AEM GPS Module features a a 5Hz GPS/GLONASS receiver, external antenna, and AEMnet/CAN 2.0 output in a
weather resistant enclosure. The GPS Module is ideal for generating track maps when used in concert with an AEM ECU
and AEMData analysis software.
Features
·
5Hz GPS/GLONASS GPS receiver
·
Latitude, Longitude, Speed, Altitude, Course, Satellite
Count, UTC Time, UTC Date
·
External magnetic antenna
·
Supports vehicle/system voltages up to 16V
·
Low-profile, weather resistant enclosure
·
AEMnet (CAN bus) Output
PN
Description
35-2207
MODULE, GPS
10-2207
INST, GPS MODULE
1-3079
ANTENNA, GPS/GNSS
4-4065
VELCRO, 1.25" (2)

2
5/31/2017 - DOCUMENT NUMBER: 10-2207 © 2017 AEM Performance Electronics
30-2207 GPS Module
Installation
The GPS Module is equipped with an AEMnet connector (power, ground, and CAN) so that it is a true plug and play
experience when used with other AEMnet products such as the Infinity ECU and CD series of dash displays.
Ideally, the GPS Module should be installed inside the vehicle in an area away from extreme temperatures or moisture.
The module should be mounted using the provided "hook-and-loop" material or may be more rigidly mounted using
fasteners through the module's mounting ears. Take care to avoid over-torquing mounting fasteners, if used.
The antenna should be mounted in a location where the top is pointed towards, and has a clear view of, the sky. The
bottom of the antenna is magnetic or additional hook-and-loop material is provided for mounting; the dashboard or rear
package shelf are not acceptable locations. The antenna should be mounted as high as possible in the center of a metal
roof away from other antennas or structures. If the roof of the vehicle is non-metallic then a flat piece of metal at least five
inches in diameter, to function as a ground plane, should be fabricated upon which the antenna should be placed.

3
5/31/2017 - DOCUMENT NUMBER: 10-2207 © 2017 AEM Performance Electronics
30-2207 GPS Module
Status LED
There is a status LED located on the top of the GPS Module that gives an indication of its operating status, specifically
the quality of the current GPS signal:
LED
Description
OFF
The device is not powered
FLASHING RED
No valid GPS fix
RED
Valid fix, zero satellites in view
FLASHING GREEN
Less than 4 satellites in view
GREEN
4 or greater satellites in view
OTHER
Please contact AEM Support
Channels / Data
GPS
The GPS Module utilizes an internal 5Hz GPS/GLONASS receiver with a matching external active antenna. Faster time
to fix, and better global coverage is afforded by the support of both the GPS and GLONASS constellations. The module is
designed with an internal super capacitor that will retain the last known satellite position (ephemeris) while power is
disconnected from the unit for up to 2.5 hours. This will allow for a very fast time to fix (<1 sec typ) once the device is
turned on again; if power is removed for greater than the 2.5 hours then the time to fix will increase. The capacitor is
automatically recharged and never needs to be replaced such as is the case with a more traditional battery.
The following GPS channels are output on AEMnet for logging on your Infinity ECU or other device:
Channel Name
Notes
GPS Latitude [deg]
+ = North, - = South
GPS Longitude [deg]
+ = East, - = West
GPS Speed [mph]
Speed
GPS Altitude [ft]
Above Mean Sea Level (MSL)
GPS Course [deg]
Course over ground, NOT heading
GPS Satellite Count
"Visible" number of satellites
GPS Valid
1 = Valid Fix, 0 = No Fix
GPS Year
UTC Time
GPS Month
UTC Time
GPS Day
UTC Time
GPS Hours
UTC Time
GPS Minutes
UTC Time
GPS Seconds
UTC Time

4
5/31/2017 - DOCUMENT NUMBER: 10-2207 © 2017 AEM Performance Electronics
30-2207 GPS Module
AEMnet (CAN Bus) Output
WHITE WIRE WITH BLACK STRIPE = AEMnet+ / CANH
GREEN WIRE WITH BLACK STRIPE = AEMnet- / CANL
The AEMnet output is suitable for output to AEM devices such as the CD Dash, AQ-1 data logger, or Infinity ECU. The
following CAN configuration and message definition information is provided below to facilitate interface with third-party
devices.
Bus Termination
All AEMnet/CAN networks must be terminated to have an
equivalent of approximately 60 Ohms of resistance.
Generally, this means a 120 Ohm resistor connected in
parallel to AEMnet+/AEMnet- (or CANH/CANL) at both
physical ends of the bus run. The unit does not have any
internal termination and is intended to be connected to a
pre-existing, properly terminated network. Please refer to
the Bosch CAN2.0B specification for further detail.
bitrate
500
kb/sec
format
29
bitID
transmitrate
100
hz
terminatingresistor
none
endianness
big / Motorola
DLC
8
0x0000A0000 at 10hz
Byte
Label
Data Type
Scaling
Offset
Range
0
GPS Latitude
32 bit float
Degrees
0
+90.00 (north) to -
90.00 (south) Degrees
1
reference
2
WGS-84 datum
3
North is positive
4
GPS Longitude
32 bit float
Degrees
0
+180.00 (east) to -
180.00 (west)
Degrees
5
reference
6
WGS-84 datum
7
East is positive
0x0000A0001 at 10hz
Byte
Label
Data Type
Scaling
Offset
Range
0
GPS Speed
16 bit unsigned
0.01 mph/bit
0
0 to 655.35 MPH
1
2
GPS Altitude
16 bit signed
1 ft/bit
0
-32,768 to 32,767 Feet
3
4
GPS True Course
16 bit unsigned
0.01 deg/bit
0
0 to 655.35 degrees
5
6
GPS Satellites in Use
8 bit unsigned
1
0
0 to 255 Satellites
7
GPS Valid
8 bit unsigned
0 = N/G, 1 = OK
0
0 to 255
0x0000A0002 at 5hz
Byte
Label
Data Type
Scaling
Offset
Range
0
GPS Valid
8 bit unsigned
0 = N/G, 1 = OK
0
0 to 255
1
UTC Date Year
8 bit unsigned
1
0
0 to 255 Years
2
UTC Date Month
8 bit unsigned
1
0
0 to 255 Months
3
UTC Date Day
8 bit unsigned
1
0
0 to 255 Days
4
-
-
-
-
-
5
UTC Time Hours
8 bit unsigned
1
0
0 to 255 Hours
6
UTC Time Minutes
8 bit unsigned
1
0
0 to 255 Minutes
7
UTC Time Seconds
8 bit unsigned
1
0
0 to 255 Seconds

5
5/31/2017 - DOCUMENT NUMBER: 10-2207 © 2017 AEM Performance Electronics
30-2207 GPS Module
12 Month Limited Warranty
Advanced Engine Management Inc. warrants to the consumer that all AEM High Performance products will be free from defects in material and
workmanship for a period of twelve (12) months fromdate of the original purchase. Products that fail within this 12-month warranty period will be
repaired or replaced at AEM’s option, when determined by AEMthat the product failed due to defects in material or workmanship. This w arranty is
limited to the repair or replacement of the AEM part. In no event shall this warranty exceed the original purchase price of the AEM part nor shall
AEMbe responsible for special, incidentalor consequential damages or cost incurred due to the failure of this product. Warranty claims to AEM
must be transportation prepaid and accompanied with dated proof of purchase. This warranty applies only to the original purchaser of product
and is non-transferable. All implied warranties shall be limited in duration to the said 12-month warranty period. Improper use or installation,
accident, abuse, unauthorized repairs or alterations voids this warranty. AEM disclaims any liability for consequential damages due to breach of
any w ritten or implied warranty on all products manufactured by AEM. Warranty returns will only be accepted by AEM when accompanied by a
valid Return Merchandise Authorization (RMA) number. Product must be received by AEMwithin 30 days of the date the RMA is issued.
UEGOoxygen sensors are considered wear items and are not covered under warranty.
Please note that before AEM can issue an RMA for any electronic product, it is first necessary for the installer or end user to contact the EMS
tech line at 1-800-423-0046 to discuss the problem. Most issues can be resolved over the phone. Under no circumstances should a system be
returned or a RMA requested before the above process transpires.
AEM will not be responsible for electronic products that are installed incorrectly, installed in a non-approved application, misused, or tampered
with.
Any AEMelectronics product can be returned for repair if it is out of the warranty period. There is a minimumcharge of $50.00 for inspection and
diagnosis of AEMelectronic parts. Parts used in the repair of AEM electronic components will be extra. AEM will provide an estimate of repairs
and receive written or electronic authorization before repairs are made to the product.
Specifications
Dimensions
width
2.6 / 66
in / mm
length (incl coax)
2.3 / 58
in / mm
height
0.8 / 21
in / mm
SupplyVoltage
min
7
VDC
max
18
VDC
SupplyCurrent (13.8V)
nominal
175.0
mA
Operating Temperature
min
-4 / -20
degF / degC
max(16VSupply)
185 / 85
degF / degC
CAN2.0B Output
bit rate
500
kb/sec
format
29
bit ID
terminating resistor
none
endianness
big / Motorola
DLC
8
GPS
Channels
52, parallel tracking
Correlators
~400,000
Frequency(GPS)
(L1) 1,575
MHz
Frequency(GNSS)
(FDML1) 1,602
MHz
Tracking Sensitivity
-165
dBm
Horizontal Position Accuracy
<2.5m CEP (SA off)
Time To First Fix - TTFF*
Obscuration recovery
0.1
sec
Hot start^
<1
sec
Warm
<30
sec
Cold
<35
sec
Notes
*=theoretical minimum values;valuesin real worldmaydiffer
^=Hot startbattery backup lasts 2.5hr w/o 12V supply
Table of contents