Agema AG6248C User manual

!
Instruction to load AG6248C-POE ONIE
!
NOTE:!Please!follow!the!steps!carefully!because!you!are!going!to!erase!and!
overwrite!NAND!storage!
Pre-install connectivity
1.Connect the console port of the switch to a PC. Most switches come
with a RJ45 console port. Use a RJ45-to-serial cable or an RJ45-to-
USB cable to connect to a PC.
2. Use a terminal application; such as “Tera Term” to terminal connect.
Configure the console port. Use these settings for the console port:
• 115200 baud
• No flow control
• 1 stop bit
• No parity bits
• 8 data bits
!
3-!Connect!MGMT!port!of!the!switch!to!the!same!segment!as!TFTP!server!
!
Installing the ONIE binaries
1.!Uncompressed!ONIE!image!that!you!have!downloaded!and!place!it!on!
TFTP!server!root!
!
2.!Install!ONIE!kernel!( 20160309-onie-agema_ag6248c-poe-r0.bin )
!
NOTE:&&Following!directions!assume!the!files!are!on!the!root!of!the!TFTP
server!with!following!ip!and!server!name:!
hostname:**tftp-srv*
TFTP*IP*:**192.168.1.5*
!

!
3.Get!into!loader!cli,!run!the!following!commands.!
Power!up!the!switch.!!!
During!power!up!press!any!key!on!the!terminal!to!get!loader!CLI:!
!
agema_ag6248c-poe ->
!!
Follow!these!steps!CAREFULLY:!
agema_ag6248c-poe -> setenv ipaddr 192.168.1.1
agema_ag6248c-poe -> setenv serverip 192.168.1.5
agema_ag6248c-poe -> tftp 20160309-onie-agema_ag6248c-poe-r0.bin
&& nand erase 0 0xa00000 && nand write $loadaddr 0 $filesize
agema_ag6248c-poe -> nand read $loadaddr onie && nand write
$loadaddr onie2
4.Power(up(the(switch(
(
(
NOTE:(During(the(first(boot(you(will(see(few(pages(of(debug(data.((((This(should(take(
no(more(than(a(min(
(
You(should(get(ONIE(prompt(when(done:(
(
ONIE:(#(
(
(