AIR GAP TAP-A-FLOW AG250-203 User manual

TAP-A-FLOW™
KITCHEN /BATHROOM
PEDAL
STAINLESS STEEL FINISH
Placentia, California
Model:
Part No.
AG250-203
Doc. # 400-0789-001
500 Jefferson Street, Placentia, California 92870 USA • 949-955-3928 • Email: [email protected]
Copyright 2018 AIR GAP INTERNATIONAL
AG250-203
During installation, avoid bending valve actuating. Any bending needs to be
smooth.
CAUTION:
Press the pedal on depressed position, open the faucet, and adjust
it to the desired water temperature and flow rate.
As long as the pedal is depressed, water will flow from the faucet.
When the pedal is released, the water flow stops.
4.
FIG. 5
Use provided #10 screws in
length 1" or 3/4" depending on
cabinet thickness to attach
pedal. (FIG.5)
3.

6 – 4-40 pedal plate mounting screws
1 – Pedal mount
Installation Procedures
AG250-203
LIST OF PARTS ENCLOSED
The AG250-203, in combination with
AG250-002 valve, provides hands-free
faucet operation. Valve is ordered
separately.
Please read the instructions once through before starting.
PEDAL INSTALLATION INSTRUCTIONS
-OVER-
1 –Screwdriver
AG250-002
Cold/Hot Potable Water
Mechanical Valve
1 – Top mounting plate
Pass cable from the AG250-002 valve through the 1"
opening under the cabinet plate and connect it to the
pedal AG250-103.
2.
FIG. 2
31
2
4
5
6
Unscrew the front nut (1) on the valve cable and insert
the cable (4) through the slot on the back side of support
bracket AG250-203 pedal. The rear nut (3) remains at the
end of the thread (2). Adjust cable holder (2) for proper
pedal operation and secure its position with nuts (1) and
(3). Control cable (4) should be snug. (FIG. 2)
Verify that valve actuating cable is inside the
valve receptacle( FIG.3)
FIG. 3
Insert valve cable end T-bar (5) into the pedal
lever (6) (FIG. 2)
1 – Pedal plate
2 – #10x3/4 " length mounting screws
2 – #10x1" length mounting screws
7
Connect pedal plate to the pedal mount using
six provided 4-40 screws (7). (FIG. 4)
3.
FIG. 4
Measure 1" from the bottom
of cabinet aligned with top
mounting plate, drill 1" hole
under the cabinet plate.
(FIG.1 )
1.
FIG. 1
1"
1" Diameter
Openings for
#10 screws
Apply top mounting plate at
the edge of the cabinet and
mark position of mounting
screws.Drill two holes for #10
screws. (13/64"). (FIG.1 )