Air King AKSF-40BK User manual

16”(40cm) Stand Fan with Remote Control
Instruction Manual
AKSF-40BK
WARNING To reduce the risk for fire, electric shock or personal injury
•Do not use this fan with any solid-state speed control device.
•Unplug the fan before cleaning or servicing.
•To reduce the risk of electric shock and injury to persons, do not use in window.
PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS
This fan is for residential use only. It is not intended for use in commercial or industrial
settings.

2
Important instructions
Read and save these important safety
instructions before using this fan, when
using electrical appliances, basic safety
precautions should always be followed
including the following:
WARNING - To reduce the risk of fire or
electrical shock, do not use this product
with any solid state speed control device.
To reduce the risk of fire or electric shock
and injury to persons, do not use in a
window.
-Use this fan only as described in this
manual. Other uses not recommended
may cause fire or electric shock.
-This product is intended for
HOUSEHOLD USE ONLY and not for
commercial, industrial or outside use. To
protect against electrical shock, do not
place fan in window, immerse unit, plug
or cord in water, or spray with liquids.
-Unplug the fan from the outlet when not
in use, when moving fan from one
location to another and before cleaning.
-Do not operate the fan in the presence
of explosive and/or flammable fumes.
-Do not place the fan or any parts near
an open flame, cooking or other heating
appliance.
-Avoid contact with moving fan parts.
-To disconnect, grip the plug and pull it
from the wall outlet. Never yank the
cord.
-The use of attachments is not
recommended and may cause hazards.
-Always use on a dry, level surface.
-Do not operate if the fan housing is
removed or damaged.
-Discard fan or return to an authorized
service facility for examination and/or
repair.
-Do not run cord under carpeting. Do
not cover cord with throw rugs, runners,
or similar coverings. Do not route cord
under furniture or appliances.
-Arrange cord away from traffic area and
where it will not be tripped over.
Assembly
1. Place the base on a flat
surface. Remove the
locking mechanism from
the pole and insert the pole
onto the base.
2. Turn over the base with the
pole inserted and secure by
turning the locking
mechanism clockwise until completed
fastened.
3. Place the motor assembly and
control panel onto the extension pole
and secure by turning the assembly
knob clockwise.
4. Remove the rear grill mounting nut
by turning it counter-clockwise.
5. Place the rear grill onto
the motor housing
aligning the 3 raised
knobs on the top of the
motor housing with the
3 holes on the grill.
6. Place the rear grill
mounting nut and
tighten turning clockwise.
7. Align the blade onto the
shaft and secure it by
tightening the blade
knob counter-clockwise.
8. Fix the front grill and the
rear grill with the circlip
and fasten the ring
around the grill. You will
hear a click sound
around the grill.
9. Then use the fasten clip
to tighten the fan grill.
10. Secure further with the
screw and tighten with a
screw driver.
How to operate

3
1. Make sure that the fan is on a firm,
level surface.
2. Making sure the speed control is at
OFF position.
3. Plug the power cord into the socket.
4. Plug the cord set into the outlet.
On/Off:
To turn fan on, press the Power button.
Sound Level/Speed Control:
Press the Fan button repeatedly to
change level. This fan has up to five
speeds to select from.
Auto-off Timer:
This setting will automatically turn your
fan off after 2, 4, or 8 hrs.
1 hour: Press one time
2 hours: Press two times
4 hours: Press three times
8 hours: Press four times
Turn Timer off: Press five times or
press power button
5. Oscillation can be activated by pushing
the bar downward and the fan can be
made to operate in a stationary position
by gently pulling the knob.
Remote control
1. Install batteries (not supplied) as
shown. The battery is size “AAA”.
2. All the functions performed with
the Remote-Control work
identically to the Manual Controls.
3. Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel- cadmium) batteries.
4. DO NOT DISPOSE OF BATTERIES IN FIRE.
BATTERIES MAY EXPLODE OR LEAK.
Cleaning
1. Be sure your fan is in the OFF position.
2. Unplug the fan before cleaning.
3. Use only a soft, damp cloth to gently
wipe the fan.
4. Do not immerse the fan in water and
never allow water to enter the Motor
Housing.
5. Do not use gasoline, paint thinner or
other chemicals to clean the fan.

4
Description of parts
1. Front grill
2. Grill protective ring
3. Blade knob
4. Blade
5. Rear grill mounting nut
6. Rear grill
7. Shaft
8. Motor assembly
9. Oscillating pin
10. Remote storage
11. Control panel
12. Inner pole
13. Height adjuster
14. Outer pole
15. Base
16. Base locking mechanism
17. Remote control
18. Fasten clip
Technical Specifications
Model: AKSF-40BK
Power Supply: 220-240V~ 50Hz
Rated Power: 50W
Class II
Conforms to all relevant
European Directives.