Airbi MAGIC User manual

EN
Aromatherapy diffuser
Airbi MAGIC
Instruction manual
(version 1.0)
Please read the instruction manual carefully before using this appliance!
Page 1 of

EN
Important safety instructions
Please read through the operating instructions carefully before you use the appliance for the first
time and keep them safely for later reference. If necessary pass them on to the next owner.
1. The appliance is only to be used in the home for the purposes described in these instructions.
Unauthorised use and technical modifications to the appliance can lead to danger to life and
health.
2. This appliance can be used by children aged from 10 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children without supervision.
3. After unpacking, make sure that diffuser wasn't damaged during transport. If you find any
damage, contact your dealer as soon as possible. We recommend you keep the packaging for
possible future use .
. Before first use check that the device parameters (electric voltage, etc.) correspond to local
conditions.
5. Do not inhale!
6. Use appliance in an environment of 10°C to 30°C. Do not use outdoors.
7. Do not place the appliance near a heat source. Do not subject the power cord to direct heat
(such as a heated hotplate, open flames, hot iron sole plates or heaters for example). Protect
power cords from oil.
8. Always put the diffuser on a hard, flat horizontal surface, at least 15cm from the walls and
away from any source of heat such as burners, radiators etc. The diffuser cannot operate on a
surface that is not horizontal.
9. Before using the diffuser, check if AC adapter or power cord is not damaged. Do not use it if
the cord is damaged.
10. If the power cord is damaged, it must be replaced by the manufacturer or a repair shop
authorized by the manufacturer or by similarly qualified persons in order to avoid a hazard
11. Only use tap water.
12. Don't exceed the maximum water level. Always put the water before essential oils. Never
use pure essential oils without water. Put some essential oils (1-2 drops). Too much drops
may damage the unit.
13. Continued use of the diffuser in the long-term damage to the product and shorten its life.
1 . Unplug the unit before any manipulation such as cleaning of filling for example. Always
empty the tank when the unit is not in use.
15. Do not remove the cover of the diffuser when the unit is running.
16. Refill frequently the water in the tank to prevent any dirt that could damage the unit.
17. Clean the water tank every week. Do not use any chemical products (acids,...) or corrosive
product to clean the device.
18. In case of splashing water in the circuit, remove the diffuser immediately and let it dry in the
open air for at least 3 days.
19. Store the appliance in a dry place inaccessible to children (pack the appliance).
20. Only use fragrances, aromas or essential oils that do NOT contain alcohol. Alcohol can
damage the appliance. Appliances that are damaged by such additives are not covered by the
warranty.
21. Manufacturer is not responsible for any damage due to improper use of appliance.
Page 2 of

EN
Diffuser's scheme
11
1. Mist nozzle
2. Upper cover
3. Base
. Light button
5. Mist button
6. Ultrasonic plate
7. Air outlet
8. Air inlet
9. Power cord jack
10. Power adapter
11. Measuring cup
Operation instruction
1. Please insert
the power cord
jack (9) into
the plug on the
back of the
appliance
2. Position the unit
on a flat and hard
surface. Remove
the upper cover
(2) from the base
(3).
3. Fill the tank
with tap water
with measuring
cup (11) to the
maximum
level.
. Add 1-2 drops of
essential oils into
water. Always fill
in water before
you add in
essential oil.
5. Place the upper
cover on the
base. Please
make sure it
fits perfectly.
6. Plug in power
adapter (10) to
socket and turn
on the appliance
using mist button
(5).
Page 3 of

EN
Light button - this button controls the light function
1. First press – 7 color rotating LED light
2. Second press – Stops light rotation, light stays on 1 color
3. Third press – Turns off light
Mist button – this button controls the mist function
1. First press – Turn on appliance (high mist mode)
2. Second press – Switch appliance to low mist mode
3. Third press – Turn off applianceLight button Mist button
Product care and maintenance
1. Before any cleaning operation, switch the appliance off and unplug it.
2. Clean the ultrasonic plate with water and vinegar on a soft cloth regularly.
3. Please don't clean the product with thinner, gasoline and cleanser.
. Please pour away the water when in no use.
5. Keep dry when in no use to avoid bacterial and mildew (fungus).
6. Never immerse the unit in water or let water enter the air outlet or any other openings.
Technical specifiations
Power supply (input): AC100-2 0V 50/60 Hz
Power supply (output): DV 2 V, 500 mA
Rated power: 12 W
Product size: 21 x 16,7 x 8 cm
Product weight: 500 g (with accessories)
Water level: 00 ml
Suitable area: 10-15 m2
Complies with EU regulations: CE, EMC, WEEE
Disposal of the device (environment)
The European directive 2012 / 19 / CE on Waste Electrical and Electronic Equipment
(WEEE), requires that old household electrical appliances must not be disposed in the
normal unsorted municipal waste stream. Old appliances must be collected separately in
order to optimize the recovery and recycling of the materials they contain and reduce the
impact on human health and the environment. The crossed out “wheeled bin” symbol on
the product reminds you of your obligation, that when you dispose of the appliance it must
be separately collected. Consumers should contact their local authority or retailer for information
concerning the correct disposal of their old appliance.
This product is in compliance with the essential requirements and other relevant provisions of EMC
directive 201 /30/EU. The device was approved for use in EU countries, therefore, bear the CE. All
necessary documentation is available at the importer address.
Changes in technical parameters, properties, printing errors in the instruction manual reserved.
Importer address:
Bibetus s.r.o.
Loosova 262/1
Brno 638 00
Czech republic
E-mail: [email protected]
Page of