AirLive ACC-DOMCAM User manual

◆AirLive ACC-DOMCAM Assembling with AirLive OD-2050HD & OD-2060HD
5. Pull out the cable. 6. Remove the cable gland out of wires.
1. Unloose the thread-lock sealing nut on the cable
glands.
2. Unloose the cable glands body with wrench.
3. Remove four bolts on the case with hexagon wrench,
which is in camera accessory pack.
4. Disconnect wires from the PCB inside.
Mounting Plate
Outdoor Mounting Kits for AirLive Vandal IP Camera
AirLive ACC-DOMCAM

◆AirLive ACC-DOMCAM Assembling with AirLive OD-2050HD & OD-2060HD
11. Place the top cover back to original position and
fasten with 4 bolts.
6. The camera is ready for mounting on the wall.
7. Put the plug, which is in camera accessory pack, to
seal the cable hole.
8. Remove the white rubber at the bottom of the
camera.
9. Let the cable wire segment go through the bottom
hole from outside. Connect the wires, color to color, pin
number to pin number to the PCB inside of the camera.
10. Place OD-2060HD/OD-2050HD on the ACC-
DOMCAM mounting plate and fasten with 3 screws.
Outdoor Mounting Kits for AirLive Vandal IP Camera
AirLive ACC-DOMCAM

◆AirLive ACC-DOMCAM Assembling with AirLive FE-200VD
2. Remove four bolts to take FE-200VD top cover out
with hexagon wrench which is in camera accessory
pack.
1. Remove four screws and mounting plate out from
AirLive ACC-DOMCAM.
3. Fix FE-200VD on AirLive ACC-DOMCAM with four
screws.
4. Make sure to put the top cover back to the right
position.
6. The camera is ready for mounting on the wall.5. Put the top cover back and fasten 4 bolts back.
Outdoor Mounting Kits for AirLive Vandal IP Camera
AirLive ACC-DOMCAM
Mounting Plate
Top