AL Tech ALHS Guide

7057 Marcelle St.
Paramount, CA 90723
800-640-0386
www.altechelectronics.com
UPDATED: 9/17/2020
Altech LED Hyper Series Area Light(ALHS)
Driver Replacement Instructions
1. Disconnect power prior to installing or troubleshooting the driver
2. Remove the screws of the driver housing (circled in yellow below) and carefully
remove the driver housing
Driver Replacement
3. Loosen the screws which holds the driver (circled in yellow below)
ALHS Driver Replacement Instructions

7057 Marcelle St.
Paramount, CA 90723
800-640-0386
www.altechelectronics.com
UPDATED: 9/17/2020
Altech LED Hyper Series Area Light(ALHS)
Driver Replacement Instructions
4. Disconnect the driver from the LED board, via the quick connectors (circled in
yellow below)
5. Cut the power wires from the driver, leaving enough lead to connect the
replacement driver, and for Altech Electronics to duly perform a Root Cause
Analysis of the returned driver (circled in yellow below)
ALHS Driver Replacement Instructions

7057 Marcelle St.
Paramount, CA 90723
800-640-0386
www.altechelectronics.com
UPDATED: 9/17/2020
Altech LED Hyper Series Area Light(ALHS)
Driver Replacement Instructions
6. Remove the existing driver and replace with the new driver. Connect the power
wires, and quick connect the driver to the LED board (circled in yellow below)
7. Tighten the screws which hold the driver (circled in green above)
8. Re-attach the driver housing, ensuring the existing gasket is properly installed
and aligned to the edge of the plate, as it acts as a seal to the xture (indicated
by the yellow arrow below)
ALHS Driver Replacement Instructions

7057 Marcelle St.
Paramount, CA 90723
800-640-0386
www.altechelectronics.com
UPDATED: 9/17/2020
Altech LED Hyper Series Area Light(ALHS)
Driver Replacement Instructions
9. Tighten the screws holding the housing plate (circled in yellow below)
ALHS Driver Replacement Instructions