Alarmcom ADC-VC725 User manual

Indoor/Outdoor Mini Bullet Camera ADC-VC725 |Setup Guide
INDOOR/OUTDOOR MINI BULLET CAMERA
SETUP GUIDE
INTRODUCTION
The ADC-VC725 from Alarm.com is a high-performance
mini bullet camera optimized for indoor and outdoor video
monitoring. Its compact design and outstanding HD quality
video make the camera ideal for both commercial and
residential video installations. The camera features a dust-
resistant exterior casing with an IP66 rating and Power
over Ethernet (PoE) capabilities.
PRE-SETUP CHECKLIST
•ADC-VC725 camera (included)
•AC power adapter (required for non-PoE connections)
•Broadband (Cable, DSL or Fiber Optic)
•Internet connection with router
•A computer or mobile device with Internet access
•An Ethernet / Cat5 cable
•Login and Password for the Alarm.com account to which you will add the camera
ADD THE CAMERA TO AN ALARM.COM ACCOUNT
Complete these steps prior to installing the camera in its final location:
1. Connect the camera to the router via an Ethernet cable.
2. If the Ethernet connection does not provide power, connect the camera to an AC power adapter and plug
the adapter into a non-switched outlet.
3. Wait 2 minutes for the camera to connect to the Internet.
4. Add the device by either selecting the account in MobileTech OR by using a web browser and entering the
following URL: www.alarm.com/addcamera
5. Select the camera from the video list or type in its MAC address to begin adding the camera. The camera’s
MAC address is located on the base of the camera.
6. Follow the on-screen instructions to finish adding the camera. You may configure camera settings from the
Customer Website.
You can now power down the camera and install it in its final location using the included hardware.

Copyright © 2016 Alarm.com |www.alarm.com |December 2016
2
Indoor/Outdoor Mini Bullet Camera ADC-VC725 |Setup Guide
TROUBLESHOOTING
If you have issues connecting the camera to the account, power cycle the camera and try again.
If issues persist, reset the camera to factory defaults by using the Reset button located under the camera cover.
•Disconnect the camera from the power supply.
•Unscrew and remove the camera cover, being careful not to damage the connecting wires.
•Using a pen or small screwdriver, press and hold the Reset button while reconnecting power. You should hear
a slight “click” when the Reset button is pressed. Continue to hold the Reset button for 10 seconds.
QUESTIONS?
Visit: www.alarm.com/supportcenter
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.