ALASKA VIV V8D User manual

Cool breeze from all angles, comprehensive ailow circulation.
Operation Manual with Warranty Card
Please read this manual thoroughly before using
and save it for future reference.
!
WALL FAN
V8D

Model
Power supply
Input Output
Watt (W)
High Low High Low
Speed (m/s)
V8D 100-240 VAC 50/60Hz DC12V / 1A 12 4.5 9 5.5
Weight
(kg)
1.6
256327
Ø122
118
364
Name Figure Spec. Quantity
Screw
DC power supply
4
Ø4x19
1
1
12V / 1A
Plastic wall anchors
Remote control
4
Ø4
125x42

Cover of wall mount

Wall mount

Power jack

Nut

Suppo

Fan






mm6OJU
Before installation please read manual carefully.
Please check the voltage before installation.
Do not modify the units.
Please follow the installation instructions.
Do not place any objects or hands into the fan while working.
Avoid installation in the location with oil fume or temperature over 40 degrees. Using under the oil fume or
high temperature will cause plastic deformation or motor broken.
Avoid using insecticides or non-neutral cleaners to spray on the fan, which will damage the plastic material.
This product is not intended for use by users(including children) who are mentally retarded or inexperienced,
except under the supervision or direction of a person who is responsible for their safety.
If the power cord is damaged, it must be replaced by the manufacturer, service agent or similar qualied person
in order to avoid hazards.
Regular cleaning and maintenance, turn othe
power when noise occurs.
Children should be supervised to ensure that they
do not play with the appliance.
PARTS LIST / DIMENSION
SAFTETY INSTRUCTIONS
SPECIFICATION

The fan is recommended to install at a min. height of 1m. Do not play with the appliance.
Use athead screwdriver to open the latch of back grill.
Before taking othe grill, please make sure the power is
turned o.

Release the nut by hand to
take othe blade.

Take othe grill.

Remove two nuts. Take othe wall
mount bracket.
  Install the fan on the wall
mount bracket, use the
nuts to rm it back.

Use four screws to x the
wall mount bracket on the
wall.

INSTALLATION GUIDE
CLEAN AND MAINTENANCE
Do not spray water on the fan,
it will cause motor failure.


Baery location/Baery spec.
7
02000190-A1
Thank you for purchasing our product(s). This warranty card provides 2-years warranty
for main parts (fan motor) and 1-year basic warranty for general parts from the date of
purchase. However, if one of the following circumstances occurs, the cost or service
fee may be charged during the warranty period.
1.The main parts are fan motors, and parts other than the main parts are all classified
as general parts.
3. Damage is caused by inadvertent or incorrect use or failure to perform regular maintenance
as required by this manual.
4.The user disassembles the product, modifies the product or uses non-original parts.
5. Damage is caused by natural disasters or force majeure.
Purchase Date Production
Serial No.
Date :
Store Stamp
The use and installation instructions must be delivered to the user.
It is strictly forbidden to install this product in a place filled with airborne grease
and room temperature up to 40 ℃ (above). You're at your own risk if you do this
to damage this product.
The method of installation is very important. Please entrust the vendor shop or plumbing
and electricity shop to install.
If the electric wires are damaged, it only can be replaced by manufacturer oragency
or plumbers to do it in order to avoid danger.
Warranty Card
Post-Service Warranty
1. During the warranty period, the product is still warranted during the original warranty
period.
2. If maintenance is conducted outside the warranty period, the repair parts are warranted
for a period of three months.
2.The warranty card has not been registered on the company's website, or the warranty
card has not been presented, or there is no date of purchase, or the seal of the distributor
has not been stamped, or the proof of time of entry has not been presented.
Please do disassemble
carefully to prevent controller
panel from damaging.
Headquaers：No.490, Shuiyuan Rd., Fengyuan Dist., Taichung City 420, Taiwan. TEL : [phone]
TEL : [phone]
TEL : [phone]
TEL : [phone]
Taipei Oce：No.98, Qiangang St., Shilin Dist., Taipei City 111, Taiwan.
Taoyuan Oce：No. 272, Ruiping Rd., Yangmei Dist., Taoyuan City 326, Taiwan.
Kaohsiung Oce：No.71, Chongwei St., Zuoying Dist., Kaohsiung City 813, Taiwan.
Install the power supply and connect the power.
There is a beeping sound from the fan.


When the fan beeps, press the pairing buon
until it beeps for the second time.
Remove the screw
on the back.
Inse1-2mm in the gap under
the controller’s base to open
the controller panel by using
a small aed screwdriver
and push the panel down.

CONTROLLER PAIRING
CHANGE THE BATTERY
Note : Please install
the controller baery
before pairing.
Instructions
Power
High
Low
Pairing