albentia ACC-A24R-S User manual

ACC-A24/30R-S
QUICK INSTALLATION GUIDE
X2 M5x12 8
X4 M6x12
24 dBi ANTENNA
30 dBi ANTENNA
TOOLS
Llave 10 mm
Llave 8 mm
* 4 pcs. in 30 dBi antenna / 2 pcs. in 24 dBi antenna.
1 RF cable
(not included)
2 serrated
fittinf
2 clamps
1 L fitting
1 5GHz
illuminator
4 M6x30 screws (30 dBi)/
M5x30 (24 dBi) with nuts
and washers
2 hald
grids
M6x12 screws (30 dBi)/
M5x12 (24 dBi) with nuts
and washers *
2. MOUNTING THE L-FITTING
1. ENSAMBLAJE DE LAS MEDIAS REJILLAS
MATERIALS
X2 M5x30
X2 M6x30
10
8
10
24 dBi antenna
30 dBi antenna
24 dBi antenna
30 dBi antenna

IMPORTANT NOTE
Albentia Systems declares that this equipment complies with the essential requirements and other relevant demands established in the Directive 1995/5/EC. CE Marking
ensures the free movement of the product within the EU and EFTA single market (total 30 countries). A copy of the “Declaration of Conformity (DoC)” document may be
obtained in this link:
http: //www.albentia.com/Docs/CEcompliance.pdf
X1
X1
7. MOUNTING THE RF CABLE
5. MOUNTING THE U-HARDWARE FOR ADJUSTABLE LIFTING
4. ASSEMBLY OF THE HARDWARE IN U FOR ELEVATION 0º
* The arrows marked POL should line up
with the grid.
3. MOUNTING THE ILLUMINATOR
* Rear of the antenna.
X2
X2
* Place the washers and nuts on the side inside of the
hardware: flat at the bottom and thick at the top.
* Place the washers and nuts on the side inside of the
hardware: flat at the bottom and thick at the top.
6. MOUNTING ON THE MAST
* Vulcanize the connector.
X2 M5x30 24 dBi
X2 M6x30 30 dBi 10
8
10
Albentia Systems S.A.
C/ Margarita Salas, 22 - 28918 Leganés - Madrid (SPAIN)
Tel.: [phone]
Fax: [phone]
E-mail: [email protected]
www.albentia.com
ACC-A24/30R-S INSTALLATION GUIDE
All Albentia Systems products are designed and manufactured in the European Union