ALC AWF71D Installation guide

AWF71D Video Doorbell FAQ’s
•My phone keeps disconnecting from the Video Doorbell during setup
oThe Video Doorbell uses Bluetooth during the setup process
oEnsure Bluetooth is turned On on your phone and is not connected to any
Bluetooth devices
oEnsure that Data is turned Off on your smartphone and the phone is
connected to your Wi-Fi
oIf selecting Doorbell during the setup keeps failing, then select Wi-Fi camera
•I cannot connect to my Doorbell after setting it up
oIf the LED light is flashing, then the camera is not connected to your Wi-Fi
oTypically this means that you may have typed in your Wi-Fi password
incorrectly
oYou will need to reset your camera and start over
oVerify that your Wi-Fi password is correct
oYou must use standard 2.4GHz Wi-Fi and not 5GHz Wi-Fi
▪Sometimes passwords for each may be different
•My doorbell stopped working or is not getting any power
oThe voltage required for the Video Doorbell is 10-24 Vac.
oCheck the voltage at the transformer. Typically for a standard 16V
transformer it will read ~19-20 Vac.
oCheck the voltage at the Doorbell. This is typically ~2V less than at the
transformer.
oIf you are not getting any voltage reading at the doorbell, then that means
there is a disconnect or “short” somewhere in the wiring. This will need to be
diagnosed by an electrician.
•How do I reset my camera?
oThe reset button is located on the back of the Video Doorbell
oPress and hold the reset button for 10 seconds
oThe LED light around the Doorbell button will start to flash rapidly

•What is my Admin Password?
oThe default Admin Password is 123456
oThis can be changed once in the Advanced Settings
•What is the Security Code?
oThe default Security Code is 123456
oBut during the camera setup, it is required that you change it to your own
oIf you cannot remember what the Security Code is, you must reset your
camera back to factory defaults, delete the camera setup in the ALC SightHD
app, and set the camera back up as if it were brand new
•One of my mounting brackets is broken
oThere are 2 mounting brackets included in the box. One has “tabs” on it and
the other has the tabs removed.
oThe bracket with tabs is the one that you must use. This clicks into the back
of the Video Doorbell.
oThe other bracket (without tabs) can be used if extra angle is needed for
better viewing. This will just be added behind the main bracket when
mounting to the wall.
oEach bracket angles the Video Doorbell 15⁰

With Tabs:
Without Tabs:
•How do I remove the Video Doorbell from the bracket?
oYou will need to insert a small screwdriver or paper clip in between the
doorbell and the bracket release tab and push out.

•There is a constant “humming” sound coming from my indoor mechanical chime
now
oTo eliminate (or greatly reduce) the hum, we recommend adding a 2W 15
Ohm resistor to the chime electrical connection
•I have a digital door chime and it is not working with the Video Doorbell.
oEnsure that you have added the Digital Adapter to the digital chime
oYou will also need to go into the Advanced Settings for the Doorbell to
change the Doorchime Type setting to Digital Chime.
oAlso adjust the time depending on how long the melody is on your digital
chime.