Alder EEVA Series User manual

For all servicing needs, please contact CUSTOMER SERVICE on:
FREECALL: 1800 800 919 PHONE: [phone] FAX: [phone] EMAIL: customer.ser[email protected]
www.aldertapware.com.au V191007
EEVA WALL BASIN/BATH SETS
EEVA WALL BASIN/BATH SET BACKPLATE – RIGHT HAND
SPECIAL NOTE
Please note that this product has been assembled as a WALL BASIN SET with a 6 litres / min flow regulator
For applications where the flow regulator is not required e.g. BATH, a full flow aerator insert has been supplied
in this box
BRICK VENEER – TIMBER NOGGIN INSTALLATION
Diagram #1 Mark desired position of wall set and fit screw on left hand side of BODY ASSEMBLY
Diagram #2 With the DOTTED LINE on the wall mixer cover at the 12 O’CLOCK POSITION, use levelling
tool as shown and mark the right-hand side screw hole
Diagram #3 Fit all other screws – re-check level
BRICK MASONRY INSTALLATION
Diagram #1 Fix wall set to brickwork with self-tapping screw in 5mm drilled hole
Diagram #2 With the DOTTED LINE on the wall mixer cover at the 12 O’CLOCK POSITION, use levelling
tool as shown and mark the right-hand side 5mm screw hole
Diagram #3 Fit self-tapping screw on right hand side – check level – additional screws not necessary
Assembly is ready to be cemented in position
During cementing, check alignment with levelling tool
NIPPLE
CUTTER
REQUIRED

For all servicing needs, please contact CUSTOMER SERVICE on:
FREECALL: 1800 800 919 PHONE: [phone] FAX: [phone] EMAIL: customer.ser[email protected]
www.aldertapware.com.au V191007
GENERAL FOR TIMBER NOGIN & BRICK MASONRY
Diagram #4 Remove PLASTIC GUIDE to complete tiling
Diagram #5 After tiling, push 5MM PLASTIC SPACER over 19BP Elbow (5mm PLASTIC SPACER can be
found in rear of WALL PLATE) – use NIPPLE CUTTER* (see below) to reduce length of 19BP Elbow to a
5MM PROTRUSION FROM THE TILE FACE
Diagram #6 Remove 5MM PLASTIC SPACER and assemble CONNECTOR onto the 19BP Elbow – screw
CONNECTOR up to tile face
Diagram #7 Install WALL PLATE
Diagram #8 Complete assembly by attaching handle and spout as shown
.
* Recommended NIPPLE CUTTER – Reliance Worldwide Product Code A60-001