alfi AB2534 User manual








 













�



 
 














 
 
Q.
















-1-

※ Dimensions
=@ξ
的
F
寸
KMWE
由寸
OFKmE
(←且
Z
寸寸
qFYN
||
||
||
||
||
ll
EN
伺飞
FnFEE
口的
52
画时的马
FF
∞
mxmwE
寸
hhoxω2
※ Installation procedures
2. As shown on the 闸， insert the base(7) with protective b 佣时
(町， washer(6) and expansion plug(8) to mounting hole. After
adjusting proper 阳 sition ， mark the drill holes ac ∞ rdingly.
Then drill4 holes with size øa on the marking pla 出 S ， then
put 由 e expansion plugs(8) into the holes respectively.
-2-
1.After selecting proper position , drill a mounting hole as
shown above. If the thickness of decoration layer 注
50mm(1 31/32") , please ins 恒 11 on the floor directly.

丘 9 1 2
3.A 而 .er ∞ nnecting hot and ∞ Id supply , tum on mixer to check
for leakage with testing water p 陪 ssure ~ 1.6MPa 但 32psi).
After testing , install protective ring( 11) onto the base , then ,
fumish the floor according to 伽 e ∞ nstruction. Remove the I
1 4.lnstall the mainbody(1) as shown on the Fig. Fix the main
pro 怡 ctive ri 吨， screws(3) , spring gas 阳恼 (4) ， protective board l
I body on the base with screws and spring gaskets.
(5) and rubber plugs(6) when the cement is dry. I
J
U
J
|||
飞
5.Tighten screws(3) with allen key(12). Then ∞ nnect hand 1 6.Check for leakage after installation. Finally , push down
showe r( 9) and Main body with shower hose(10). I the decorative plate (2) close to floor.
-3-

※ Usage:
合 The usage of the handle:
1) Raise the handle to make the water flow out ，∞ ntrarily the water flow will stop.
2) Turn the handle to the left , the hot water flow will be stronger and temperatu 陪 will be higher ,
contrarily the temperature will be decreased.
Open
古 The usage of the Oiverter:
1) Push down the dive 巾 r tip to switch water from handshower to spou t.
2) Pull-up the diverter tip to switch water from spout to hand shower.
Pull-up
※ Cleaning & Maintenance
女 To keep the product clean & shining , follow the steps as below:
1. Flush with clean water & d 叩 with 80ft cloth only.
2.lfanydi 此， clean with soft liquid or t 阳 nspa 陪 ntglass det 町 en t.
Cold water
Right
3. 00 not use any scrubbing detergent , polisher , sand -c loth , paper tissue or scraper.
4. 00 not use acid detergent , indissovable grain-like detergent or soap.
5. Take out the aerator and flush away dirts when ne 四 S 臼叩.
※ This ins' 饱lI ation manual is only for your re 币 eren 饵，
the final right to explain & revise is belongs to us.
-4-